Advertisement
1. Patch output 1 of the Quad Envelope to a module with CV input for
modulation.
2. Patch a clock source into CLK IN and make sure you are receiving clock
(you will see the LED bargraph moving indicating that the sequencer is active
and you are receiving clock).
3. Patch a gate in from an external source to the GATE INPUT JACK #1.
4. Press envelope BUTTON 1
5. Set the speed (Fast or Slow).
6. Move the sliders for
ATTACK, HOLD, DECAY, SUSTAIN and RELEASE
liking. Or you can hold RECORD while moving the sliders to record slider
movements to a sequence.
7. If you have recorded slider movements to a sequence, set the switch for the
sequencer direction to your liking. You will now hear your recorded slider
movements play back in the forward, reverse, pendulum or random direction.
8. If you want to clear what you've recorded to the sequencer, hold the CLEAR
button and move a slider to clear that parameter.
9. Follow steps 1-6 on each envelope channel or change it up a bit (each
envelope channel can be fully edited).
10. There is an auto-save function. After making your final setting, wait 10
seconds before you power down. Then recycle your power and your settings
will recall on power-up. If you are using the Varigate 8+ or the Varigate 4+ on
the same power bus, you can utilize the memory power of these modules to
save Quad Envelope presets (up to 100 presets with the V8+ and 16 presets
with the V4+).
Visit malekkoheavyindustry.com to read the full manual and register your product for warranty!
YOUR FIRST PATCH
CONNECT POWER CABLE WITH
RED STRIPE TO WHITE LINE
FOR
REV
PEN
QUAD ENVELOPE
RAN
FOR
REV
PEN
RAN
CLEAR
QUAD ENVELOPE
RECORD
FOR
to your
REV
CLEAR
PEN
RAN
RECORD
CLEAR
RECORD
GATE IN
ATTACK
HOLD
DECAY
SUSTAIN
GATE IN
RELEASE
F S T
ATTACK
GATE
LOOP
HOLD
DECAY
SUSTAIN
RELEASE
F S T
GATE IN
ATTACK
GATE
LOOP
HOLD
DECAY
SUSTAIN
RELEASE
F S T
GATE
LOOP
Advertisement
