Advertisement
Quick Start Guide
Important Information
Please retain the information in this User Guide for future reference.
Please read all instructions fully before using.
To clean, wipe the product with a clean damp cloth.
Do not allow the product to come into contact with water or other liquids.
Keep the product away from direct sunlight and heat.
If your product malfunctions please switch it off and then back on again to reset it.
Batteries are to be inserted with the correct polarity.
The supply terminals are not to be short-circuited.
Only batteries of equal size and type should be used.
Know Your Stopwatch
Start/Stop Button
Lanyard
TTS Group Ltd., Park Lane Business Park,
SC01002
Kirkby-in-Ashfield, Nottinghamshire, UK NG17 9GU
Mode
Digital Display
Reset Button
TTS Basic Stopwatch
Using Your Stopwatch
Sleep Mode
When the stopwatch is not in use they will automatically enter sleep mode to conserve the
batteries. Press any button to resume operation. Stopwatch will enter sleep mode after 5
minutes of inactivity.
Changing the Display Mode
The display has been configured can be configured to show time in 3 different modes:
88'88"
88'88" 8
88'88" 88
To change the display mode, use a paper clip to toggle the concealed mode button next
to the start/stop button (see Know Your Stopwatch). Each time the button is pressed the
display will change mode.
Changing The Batteries
The stopwatch requires 1 x CR2032 lithium battery (supplied). Undo the screw to release
the battery hatch using a small screwdriver. Carefully slide the battery hatch out and lift the
exhausted battery from the battery housing. Insert the new battery carefully, making sure it
is fitted with the correct polarity. Re-fit the battery hatch and re-tighten the screw.
Specification
Battery type
www.ttsgroupsupport.com
minutes and seconds
minutes, seconds and 1/10 seconds
minutes, seconds, 1/10 and 1/100 seconds
1 x CR 2032 Coin Cell
GB
Advertisement
