Advertisement
Quick Links
WebWay Mini
Quick start guide - Mini/Smart/Go
This is a quick start guide with steps of how to commission a WebWay. For engineers guide, full instructions
and panel guides please visit www.webwayone.co.uk/support. This commissioning process is for engineers
with a site ID or chip number to enter into the WebWay. For users who have configured device on WebWay
World, please skip step 8.
Take on
*Enter the Site ID from your ARC using the buttons.
- Tap button A until menu D is displayed.
- Tap and hold button C until you see "_" on the display. - Use A to increase number
- Tap C to confirm digit
- After the final number press button C.
- A moving circle is displayed temporarily
- The display returns to menu D - reboot device
Once status lights are green, the WebWay is fully commissioned and you can test signals with your ARC. If you have
any problems, please contact technical support.
Technical support: +44 (0)1635 231 514
support@webwayone.co.uk
Advertisement
Summary of Contents for WebWay Mini
- Page 1 - A moving circle is displayed temporarily - The display returns to menu D - reboot device Once status lights are green, the WebWay is fully commissioned and you can test signals with your ARC. If you have any problems, please contact technical support.
- Page 2 CONFIGURABLE IP-Addr = SPT’s local (LAN) IP address. IP-Port = SPT's local (LAN) IP port. GW-IP-Add = IP address of the destination WebWay receiver. GW-IP-Port= IP port at the destination WebWay receiver. Router= Local router IP address. NetMask= Local network subnet mask.