Toast 6 Titanium Getting Started Guide
16
Chapter 2: Toast Basics
Number of Copies
■
want the recorder will make. Toast will prompt you for blank discs
after each copy.
3
Click the Advanced tab. In the Advanced tab, you can change the
following settings:
: From this pop-up menu, select what you want to do
After Writing
■
with the disc after recording it. Toast can mount the disc on the
desktop, eject the disc, or prompt you for either.
: Select this check box to finalize the disc so that Toast
Close Disc
■
cannot record any further sessions to the disc. (A session is a single
recording.) This is useful for making data discs that you would like
to record data to in more than one session.
Uncheck this check box if you want to record more than one
session to the disc.
: If you are making a data disc, select this check box to
Verify Data
■
automatically verify the contents of a disc against the same data on
your hard disk after recording the disc.
Uncheck this check box if you do not want to automatically verify
the contents of a data disc after recording.
Simulation Mode
■
process of recording data or audio on a disc. You might do this to
make sure that the write speed and other factors that you have set
up for your recorder are correctly in place before you start to
record to actual media.
Uncheck this box if you want to record to an actual disc.
Buffer Underrun Prevention
■
buffer underrun prevention. A buffer underrun is an error in
which your hard disk is unable to send data fast enough to the
recorder during a recording. This causes errors that make a blank
disc unusable.
: Enter the number of copies of the disc you
: Select this check box if you want to simulate the
: Select this check box to turn on
Need help?
Do you have a question about the Toast 6 Titanium and is the answer not in the manual?