Rowenta Steam 'n Press Instructions For Use Manual page 11

STEAM 'N PRESS TROUBLE SHOOTING
Problem
Leaking or
spitting.
Steam 'n
Press won't
heat.
Does not
steam.
Not enough
power or
too much
Possible Cause
Distilled water.
Softened water.
Thermostat set
incorrectly.
Overuse of burst
of steam.
Water tank.
Isn't hot enough.
Is it plugged in?
Is thermostat set
too low?
Is water in the
tank?
Burst button not
primed.
Dual voltage not
set correctly.
Solution
Never use 100% distilled water.
The Steam 'n Press is designed to
use tap water. In very hard water
areas we recommend using
bottled spring water.
If you experience spitting or
leaking with softened water,
change to untreated tap water
or bottled spring water.
The thermostat needs to be set
to the 3 dot setting to produce
steam.
Allow 4 seconds between each
burst.
Be sure that water tank is firmly
in place.
Allow Steam 'n Press to heat for
approximately 1 minute before
using.
Check plug securely in socket.
Turn the thermostat to a higher
setting.
Ensure tank has water in it.
Press the burst button 4-5 times
to begin steaming.
Be sure the dual voltage selector
is in correct voltage position
before operating. Unplug the
appliance and turn the selector
(which is below the handle) with
a coin to align it with the correct
voltage (either 120 or 240 V).
11