Advertisement
The CAP002 is designed for use with an electret condenser microphone. When connected it will boost
the microphone audio output to a level that can be used to connect to a typical auxiliary line level
input commonly found on amplifiers / mixers or recorders requiring 0.5 Volts RMS (refer to your
external equipment instruction manual).
Power requirements
An external 12V to 24 DC or 24V AC supply with 100mA capacity (not supplied) is required / available
from most high street electrical retail outlets. Some DC adaptors are supplied with a plug already
attached these will need to be removed. Important that you careful check to ensure correct +/- polarity
of the 2 cables when connecting to the CAP002 pin 1 and 2 of PL2 screw terminals.
Microphone
AC/DC power adaptor
(not supplied)
Line level Pre Amplifier CAP002
Connections
CAP002 BOARD
To Mixer Input
Advertisement
Table of Contents
Related Manuals for Clockaudio CAP002
Summary of Contents for Clockaudio CAP002
- Page 1 Some DC adaptors are supplied with a plug already attached these will need to be removed. Important that you careful check to ensure correct +/- polarity of the 2 cables when connecting to the CAP002 pin 1 and 2 of PL2 screw terminals. Connections...
-
Page 2: Power Supply Connections
Changing the audio output level (R5) The audio output level from the CAP002 is preset to give optimal sound level and in most cases will not need to be replaced. However, if you are experiencing any distortion or clipping then the output gain resistor (R5) can be adjusted giving more headroom. - Page 3 A single AC power adaptor can be used to power several CAP002 Line amplifiers. Simply parallel connect the wires from your AC adaptor to each of the CAP002 DC + / - power input screw terminals of PL2 making sure of correct polarity. See below diagram showing 3 CAP002 running of a single...
Need help?
Do you have a question about the CAP002 and is the answer not in the manual?
Questions and answers