Summary of Contents for Toolex 511182
- Page 1 511182, 511163 & 511165 PROCRAFT & TOOLEX CONCRETE MIXER 3.5CU/FT INSTRUCTION MANUAL www.toolex.com.au...
-
Page 2: General Safety Rules
GENERAL SAFETY RULES WARNING!Read all instructions Failure to follow all instructions listed below may result in electric shock, re and/or serious injury.The term“powertool” in all of the warnings listed below refers to your mains-operated(corded)powertool or battery-operated(cordless)powertool. SAVE THESE INSTRUCTIONS 1)Work area a) Keep work area clean and well lit.Cluttered and dark areas invite accidents. -
Page 3: Additional Safety Rules
e)Do not overreach.Keep proper footing and balance at all times. This enables better control of the powertool in unexpectedsituations. f)Dress properly.Do not wear loose clothing or jewellery.Keep your hair,clothing and glovesaway from moving parts.Loose clothes,jewelleryor long hair can be caught in moving parts. g)If devices are provided for the connection of dust extraction and collection facilities,ensure these are connected and properly used.Use of these devices can reduce dust related hazards. - Page 4 limitations as well as the speci c potential hazards particular to it. ●Do not operate the mixer while under the in uence of drugs,alcohol or any medication that could a ect your ability to use it properly. ●Check your mixer before turing it on.Keep guards in place and in working order.Form a habit of checking to see that keys and adjusting wrenches are removed from tool area before turing it on .Replace damaged,missingor failed parts before using it.
- Page 5 ●Always switch the mixer on when the drum is empty,beforeloading the unit with mixing material. ●Do not place the shovel into rotating drum while it is rotating. 511182 Procraft Speci ctaions 511163 Toolex Speci ctaions 511165 Procraft Speci ctaions...
- Page 6 x too tight as the shalf has to be left turning freely. 4. Put Pulley Cover/Inside #12 throught Shaft #16, x with 2 M6 × 20 Hex Bolt # 43,6mm Flat Washer #29 from one side,then 6mm Flat Washer #29,and M6 Hex Nut # 31 and tighten well (Fig.7).Put 1 M 6×...
- Page 7 Page 7...
- Page 8 Page 8...
- Page 9 Page 9...
- Page 10 Lock Plate∮16 Hex Bolt M10X30 Flat Washer 10mm Hex Nut M10 Split Pin 5X40 Hex Sel ock Nut M 16 Hex Bolt M6X20 Flat Washer 6mm Sel ock Nut M 6 Hex Bolt M8x20 Flat Washer 8mm Hex Nut M8 Flat Key 5x35 Inner Hex Lock Pin M8x16 Hex Bolt M12x50...
- Page 11 Page 11...
- Page 12 Warranty Against Defect Toolex Industrial & Gasweld Tool Centre this product for a full replacement or refund for:12 months from date of purchase. This guarantee covers material and workmanship defects only. In order for the guarantee to be acted on,the consumer must use the products strictly in accordance with their operating manual and for the purpose for which they are intended to be used.This guarantee does...
Need help?
Do you have a question about the 511182 and is the answer not in the manual?
Questions and answers