Table of Contents
Advertisement
Quick Links
USER GUIDE
Your ZINGO X300 warranty must be registered online within 7 days of purchase.
To activate your warranty visit www.tevo.co.za and click the "Register your warranty" tab at the top of the web page.
Complete the form, enter your serial number (found on the scooter fork) and agree to the terms and conditions.
Advertisement
Table of Contents
Summary of Contents for Zingo X300
- Page 1 USER GUIDE Your ZINGO X300 warranty must be registered online within 7 days of purchase. To activate your warranty visit www.tevo.co.za and click the “Register your warranty” tab at the top of the web page. Complete the form, enter your serial number (found on the scooter fork) and agree to the terms and conditions.
- Page 2 IMPORTANT BATTERY CARE AND MAINTENANCE Make sure that your ZINGO X300 is fully charged prior to initial use. The rst charge will take 12 hours. Wait for the full 12 hour charge period before unplugging 2. Always charge your ZINGO X300 after every use 3.
-
Page 3: Installing The Handlebar
FAMILIARIZING YOURSELF WITH YOUR ZINGO X300 Throttle Handlebar tightening knob Hand-operated rear brake Handle stem Brake caliper 300W Motor Foot stand Fuse/Reset Rear wheel On/O switch 10. Rechargeable 24V Battery 11. Fold mechanism 12. Carry strap Front wheel INSTALLING THE HANDLEBAR... -
Page 4: Battery Care
ZINGO X300 just beneath the deck. Prior to rst use your ZINGO X300 must be charged for 12 hours. Even if the green light comes on, disregard this and leave the unit charging for the full 12 hours before unplugging. -
Page 5: Service Centres
FUSE/RESET If your ZINGO X300 happens to suddenly stop working, check the fuse located below the deck on the left-hand side of the scooter above the charging port. The fuse may have shorted if the motor was overloaded. If so, replace the fuse and correct the riding conditions that caused the overload. -
Page 6: Troubleshooting
TROUBLE SHOOTING Problem Possible Cause Solution Scooter does not run Undercharged battery Ensure that your scooter is fully charged. The rst charge should not be longer than 12 hours and subsequent charges should not be more than 5 hours Check all connectors. If charging, make sure that the charger is correctly connected to the charging port, and that there is power to the charger Scooter suddenly... -
Page 7: Battery Disposal
• If not being used, your ZINGO X300 must be charged frequently (at least once every two weeks) and not left standing for lengthy periods of time. If left uncharged for a prolonged period the batteries will no longer produce the necessary charge needed to run the product. - Page 8 Brought to you by: 0861 77 88 88 www.tevo.co.za | info@tevo.co.za...