SUNSTONE SS-PSTAT Easy Programming Manual

Setting the Time & Day
Step 1 Press the SET button once and the hour will flash on the display.
Step 2
Set the hour by pressing the
the arrow down to set the hour faster.
Step 3 Once you have selected the correct hour press SET again and the minutes will now flash.
Step 4
Set the minute by pressing the
Hold the arrow down to set the minutes faster.
Step 5 Once you have selected the correct minutes press SET again and the day of the week will
now flash. The days of the week are represented as numbers 1-7, 1-5 being Monday to
Friday and 6-7 being Saturday and Sunday.
Step 6
Set the day of the week by pressing the
Step 7
Once you have selected the correct day of the week press OK to finish.

Setting into a Permanent Manual Mode

(Indicates Permanent Manual Mode)
Setting the controller into a Permanent Manual Mode will allow you to set a target temperature you want
the floor to achieve. Once the target temperature has been achieved it will maintain this temperature
until you either switch it off using the ON/OFF button below the screen or alter your target temperature.
Step 1 To set the controller into a Permanent Manual Mode press and hold the OK button for 3
seconds. A hand symbol
Step 2
Set the target temperature by pressing the
temperature and press the OK button. The
sending power to the heater.
Note:
If you would like to exit Permanent Manual mode and return to a programmed schedule
press the OK button.
Sunstone Programmable
Thermostat (SS-PSTAT)
Easy Programming Guide
or arrow until the correct hour has been achieved. Hold
or arrow until the correct minute has been achieved.
or arrow.
will appear to indicate it is set into a manual mode.
or
symbol indicates that the thermostat is
arrow until you reach your target
1