FBII Omni-KP Installation And Setup Manual

Keypad Features
Backlit Display
Built-in Sounder
®
The Omni -KP and Omni
Keypads designed for use with FBII Omni Series control
panels. Addresses are set via the keypad keys.
The keys on the keypads are continuously backlit for
convenience.
KEYPAD DISPLAYS AND LEDS
The keypads have the following display features:
Fixed
Model Word
Display Display
Omni-KP X
Omni-LCD
The following table shows the LEDs and their functions:
LED Function
Red Lights when the system is armed in any mode
Green Lights when the system is "ready" to be armed.
WIRING AND INSTALLATION
The keypads can be surface-mounted directly to a drywall, or
to a single- or double-gang electrical box.
1. Remove the case back by sliding the blade of a
screwdriver-between the tab and the case back on each
side of the keypad as shown in lower diagram at right.
2. Route wiring from the control panel through the
opening in the case back.
3. Mount the case back to a wall or electrical box. For wall
mounting of the Omni-KP/LCD in the FR, NL and IT
versions, secure the case back to the wall, being especially
careful to secure the partially knocked-out tamper switch
plunger with its own screw. This assures that separation
of the keypad from its mounting will cause the tamper
switch to activate. Any attempt to pry the keypad open
will also activate the tamper switch in these versions.
4. Wire directly from the keypad's terminal block to
the terminal block on the control board. Wire functions
are marked next to terminals. Labels are as follows: DI
Data In to Control Panel, - Ground, + Aux. Power Plus,
DO Data Out of Control Panel. See table on next page.
5. Reattach the keypad to its case back.
INSTALLATION AND SETUP GUIDE
®
-LCD are addressable Remote
2-line 2-digit
Alpha Zone
Identifier Descriptors
X
X
Omni-KP
Fixed-Word
YES
Piezo
Custom
Zone
Omni-KP w/ Protective Cover Removed
X
Omni-LCD w/ Protective Cover Removed
Separating Case Back From Top Cover
REMOTE KEYPADS
Omni ®
(Omni-LCD is not available in the U.S.)
Omni-LCD
2-Line Alpha
YES
Speaker
1 2
ARMED
STAY
READY 4 5
BYPASS
7 8
INSTANT
0
CODE
1 2
STAY
ARMED
4 5
BYPASS
READY
7 8
INSTANT
0
CODE
TO SEPARATE TOP COVER
INSERT SCREWDRIVER
AND PUSH HERE
K3590-FBIIV1 6/01
-KP & Omni ® -LCD
3
6
9
#
3
6
9
#