Page 1
Fitting the spotlight units Instruction leaflet • To fit the spotlight units, slide the tab down, and rotate the product 90 • degrees to engage the connections in the track. Cora & Bari Track Spotlights • Allow the tab to slide back up and ensure that it is located correctly in Rotate 90 • the track slot. 61522, 61523 Commissioning • Replace fuse or circuit breaker and switch on. Your light is now ready for use. Fitting/replacing bulbs • The LED module in this product is non-replaceable. We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could damage the finish.
Page 2
Installation Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. Please retain these instructions for future reference. Existing fittings must be completely removed before damaging any concealed wiring and pipes. The installation of a new product. Before removing the correct fixings should be used for brick, cavity walls Warning existing fitting, carefully note the position of each set or plasterboard. of wires. • Feed the screw through the keyhole slot, and slide This is a Class 1 product and must be earthed. If replacing an existing fitting, make a careful note of into position. Mark the position of the second hole. the connections. • Using the ceiling cover as a template, mark the first Please read these instructions carefully before Locate the track and fit the second screw into hole position and fit the screw in position as shown commencing any work. This system contains non-replaceable parts and position.