Subscribe to Our Youtube Channel
Summary of Contents for Mother's Choice flair II
- Page 1 II convertible booster MONTHS YEARS IMPORTANT: KEEP THIS BOOKLET IN THE PLACE PROVIDED ON THE CHILD RESTRAINT. Illustrations and designs may vary. follow us on motherschoice.com.au...
-
Page 2: Quick Start Guide
Harnessed mode: quick start guide convertible car seat preparing vehicle for your seat 6 months to 4 years approximately PUSH DOWN LOOSEN TOP TETHER Front of vehicle BEHIND SEAT CLICK Mother’s Choice | Flair II... - Page 3 6 months to 4 years approximately REMOVE SLACK ATTATCH TOP TETHER Front of vehicle CORRECT USE INCORRECT USE For detailed step by step installation instructions, please refer to page 23. Mother’s Choice | Flair II...
- Page 4 Removing harness FOLD LIFT FLAP ROLL TUCK INTO TRIM ROLL PULL COVER OVER BOOSTER MODE For detailed step by step installation instructions, please refer to page 25. Mother’s Choice | Flair II...
-
Page 5: Quick Start Guide
4 years to 8 years approximately PUSH DOWN ATTATCH TETHER LOOSEN TOP TETHER CLICK Front of vehicle CORRECT USE INCORRECT USE For detailed step by step installation instructions, please refer to page 29. Mother’s Choice | Flair II... -
Page 6: Table Of Contents
Correct positioning of booster seat Securing child and booster seat to vehicle care and maintenance 30-31 Buckle maintenance Fabric cleaning and care instructions Removing and fitting accessories Hardware cleaning and care instructions contacts Warranty Customer service Mother’s Choice | Flair II... -
Page 7: Before You Start
However proper use of this restraint may reduce the risk of injury or death! need assistance? Call our Customer Service Team: 1300 809 526 Monday to Friday (8:30am - 5:00pm AEST) or send an email: customerservice@dorel.com.au www.motherschoice.com.au mother’s choice follow us on motherschoice.com.au Mother’s Choice | Flair II... -
Page 8: Warnings
THIS RESTRAINT MUST BE USED IN CARS WITH FORWARD-FACING SEATS WITH A LAP-SASH SEATBELT. THIS BOOSTER SEAT IS NOT SUITABLE FOR USE WITH A CHILD HARNESS. • If the knees do not bend in front of the vehicle seat cushion continue to use a Mother’s Choice | Flair II... - Page 9 For approved aftermarket accessories please refer to page 13. • Ensure the belt webbing is not twisted. • TO BE USED WITH A LAP-SASH SEATBELT IN THE FRONT/BACK OF MOST CARS WITH FORWARD FACING SEATS. Mother’s Choice | Flair II...
-
Page 10: Next Seat For Your Child
If you answered “no” to any of these questions, your child needs to be in a booster seat to make both the sash and the lap part of the seatbelt fit right to ensure maximum crash protection. information obtained from www.raa.com.au Mother’s Choice | Flair II... - Page 11 (Marker A) or above the upper marker (Marker C, refer to page 26). The child needs to be moved into the next form of restraint when they reach the top shoulder height marker. For more information, refer to page 10. Mother’s Choice | Flair II...
-
Page 12: Markers
(both sides) Adjuster Strap Headrest Lever Top Tether Strap Top Tether Adjuster 15. Top Tether / Instruction Manual Storage Pocket Top Tether Hook Anchor Fitting Forward-Facing Belt Path Markers Splitter Plate Forward-Facing Belt Path Markers Mother’s Choice | Flair II... -
Page 13: Anchor Fitting Locations
Locking clip ref no. 015059 • Use of aftermarket accessories (i.e. items not provided in the box with the child restraint), can reduce the safety provided by the child restraint and may cause injury or death. Mother’s Choice | Flair II... -
Page 14: Installation
IS NO SLACK IN THE LIE FLAT ON THE TOP STRAP AND THE ANCHORAGE FITTING. ATTACHMENT CLIP IS UPRIGHT IN THE AN- CHORAGE FITTING. figure ANCHORAGES IN VERTICAL PANEL AT REAR OF VEHICLE figure FLOOR MOUNTED ANCHORAGES Mother’s Choice | Flair II... - Page 15 (if required) correct attachment bolt length and use of spacers. Vehicle trim In New Zealand, consult the agent for the vehicle. Vehicle metal structure Reinforcing washer Lock washer Mother’s Choice | Flair II...
- Page 16 Some vehicles do not have any seating positions that can be used safely with the seat. If you are not sure where to place the booster seat in your vehicle, consult your vehicle’s owner’s handbook. Mother’s Choice | Flair II...
-
Page 17: Forward-Facing Vehicle Position
PREPARING SEAT AND VEHICLE Correct Forward-Facing Vehicle Position CORRECT USE CORRECT USE INCORRECT USE WARNING IMPROPER PLACEMENT OF THE SAFETY SEAT INCREASES • THE RISK OF SERIOUS INJURY OR DEATH. Mother’s Choice | Flair II... -
Page 18: Adjusting Top Tether Strap
REMOVE HAZARDOUS CARGO BEFORE USING THIS CHILD RESTRAINT. THIS RESTRAINT IS NOT SUITABLE FOR USE WHERE THE TOP TETHER STRAP MAY FALL INTO A SPLIT IN THE SEAT BACK OR OFF THE SIDE OF THE SEAT. Mother’s Choice | Flair II... -
Page 19: Adjusting Harness And Seat Configuration
Reconnect the straps to the splitter plate. NOTE: Ensure the harness heights are of equal length. CORRECT INCORRECT WARNING Always adjust the height of the shoulder straps as the child • Mother’s Choice | Flair II... -
Page 20: Loosening And Fastening Harness Straps
NOTE: Remove insert if not required. PUSH 5. Fasten buckle (see page 22). 6. Pull the adjuster strap at the front of the seat until the harness straps lay firmly against the child. PULL TO TIGHTEN Mother’s Choice | Flair II... - Page 21 To adjust back to upright position: Pull the backrest of the seat forward in the upright position. Cup Holders • To use cup holders, simply swing outwards on either side. SWING • Push back when not in use. Mother’s Choice | Flair II...
-
Page 22: Buckle Fastening And Operation
2. Insert the second buckle tongue as shown. Now listen for a “click!”. CLICK! 3. Remember to always pull up on the harness straps to make sure buckle is locked tightly. WARNING DO NOT LEAVE CHILDREN UNATTENDED IN THE CAR. • Mother’s Choice | Flair II... - Page 23 5. Fasten the seatbelt, ensuring you hear a ‘CLICK’. CLICK 6. Reposition the sash-belt from the outside of the seat to the inside. The sash-belt should lay as shown as pictured. Mother’s Choice | Flair II...
- Page 24 DO NOT USE SEAT BELT EXTENDERS. NOTE: There is an option to install seat using seat belt with accessory locking clip. Please see instructions provided with locking clip for installation. CORRECT INCORRECT Mother’s Choice | Flair II...
-
Page 25: Removing The Harness For Booster Use
5. Lift the trim up to expose the adjuster strap. Pull the adjuster strap to full length, then roll the strap tightly until it reaches the harness release lever. Pull cover over, back into place. PULL COVER OVER ROLL Mother’s Choice | Flair II... - Page 26 The child needs to be moved into the next form of restraint when they reach the top shoulder height marker. For more information, refer to page 10. Mother’s Choice | Flair II...
- Page 27 Booster Seat Belt Path Markers (both sides) Headrest Lever Top Tether Strap Top Tether Adjuster 11. Top Tether / Instruction Manual Pocket Top Tether Hook Anchor Fitting Harness Strap Storage Location Booster Seat Belt Path Markers Mother’s Choice | Flair II...
-
Page 28: Correct Positioning Of Booster Seat
CAUTION: In the event of a crash, a seat belt across the child’s throat could cause a strangulation hazard. INCORRECT INCORRECT CORRECT WARNING: A SASH BELT UNDER THE ARM OR BEHIND THE BACK IS DANGEROUS. Mother’s Choice | Flair II... -
Page 29: Securing Child And Booster Seat To Vehicle
The lap belt portion MUST be positioned low on the hips. ALWAYS USE THE SASH GUIDE. SASH GUIDE Fasten buckle and pull up on the shoulder belt to tighten. NOTE: The vehicle’s seatbelt CLICK MUST NOT be twisted. Mother’s Choice | Flair II... -
Page 30: Buckle Maintenance
Metal Plate (Figure 1b) into a loosened position, repeat on the other side. Turn each metal plate and push through the top opening to release crotch buckle for cleaning (Figure 1c). Mother’s Choice | Flair II... - Page 31 If the buckle does not return to original working order, contact Dorel Australia Customer Service on 1300 809 526. • If you are a New Zealand customer, please contact IGC Dorel New Zealand Customer Service on 0800 628 000. Mother’s Choice | Flair II...
- Page 32 Start by fitting on the armrest, then place the trim on the back. Pull elastic under the base and over the cup holders, then fasten the velcro under the base and on the back of the trim. Mother’s Choice | Flair II...
-
Page 33: Removing And Fitting Accessories
To remove the headrest, simply undo the velcro tabs from the sash guide and pull the insert out. To replace headrest: Fit headrest inserts to seat by stretching it over the headrest and securing velcro tabs around the sash guide. VELCRO TABS Mother’s Choice | Flair II... -
Page 34: Hardware Cleaning And Care Instructions
For approved aftermarket accessories please refer to page 13. VERY IMPORTANT: Only replace the cover with a manufacturer’s supplied replacement cover with identical shoulder height markers or a replacement cover meeting AS/NZS 8005. Mother’s Choice | Flair II... -
Page 35: Warranty
Australian Standard AS/NZS 1754 Lic 40071 SAI Global IMPORTANT: KEEP THIS INSTRUCTION MANUAL IN THE POCKET PROVIDED AT THE REAR OF THE SEAT. Mother’s Choice | Flair II... -
Page 36: Customer Service
motherschoice.com.au follow us on DOREL AUSTRALIA PTY LTD IGC DOREL NEW ZEALAND LTD 655-685 Somerville Road 14 Sir William Avenue Sunshine West Victoria 3020 East Tamaki Auckland 2013 Hours: 8:30 am - 5:00 pm Mon-Fri Hours: 8:00 am - 5:00 pm Mon-Fri Email: customerservice@dorel.com.au Email: customerservice@dorel.co.nz Phone: 1300 809 526...
Need help?
Do you have a question about the flair II and is the answer not in the manual?
Questions and answers