Table of Contents
Advertisement
DETAILING THE INTERIOR
1. Installing Headliner
Tools Required
Parts Required
Refer to Figures 65 through 70
Paint contact cement on headliner where headliner will meet the raised areas of the inner liner as shown in Figure
66. Do not apply cement to eh very rear edge of the headliner. This area must remain accessible for the installation of the
tail pins and adjuster stop. Cut a slot in the headliner for the overhead console wiring harness to be pulled through as
shown in Figure 66. Paint cement on the raised areas of the inner liner as shown in Figure 67.
Figure 65 Headliner
1-1/2 inch paint brush
Trim Knife
Ff #MX194 Contact Cement
Ff #Z759L Headliner
Advertisement
Table of Contents
