Signature SG22159 Assembly And Care Instructions

Lotus Buddha Fountain
sG22159
Please read these assembly and care instructions carefully, and observe the safety directions.
Keep these details in a safe place for future reference.
Component List
1 x fountain body with LED light set up
1 x pump with cable
1 x transformer
1 x cover plate

instaLLation instruCtions

1. Choose a level surface to set up your fountain,
and place the fountain base on the ground.
2. Connect the plastic hose to the inlet on the
pump. Connect the LED cable (Fig. A).
Please see over for important safety, care and troubleshooting information.
3. Sit the pump in the base of the fountain, and press
down gently so the suction cups grip firmly.
4. Slide the cover plate over the opening
at the rear of the fountain (Fig. B).
5. Connect the transformer to the power cable,
and screw together tightly (Fig. C).
6. Fill the fountain with clean water, and ensure the
pump is fully submerged. The water level should
be about 2cm below the rear opening (Fig. D).
7. Connect the plug to your power outlet.
8. Sit back, relax and enjoy!