Page 2
Triple Axle Equalizer Options Two Road Armor Triple Axle Equalizers are available, including long arm and short arm versions, with utilization dependent on axle spacing. Trailers that measure 35” from the center of the first wheel to the center of the second wheel will use the 9.54”...
Page 3
Installation Rear Equalizer (Between 2 and 3 Axles) NOTE: Support framework in accordance with manufacturer's recommendations. NOTE: When utilizing the Correct Track system, the shorter shoulder bolt will be used to install the rear equalizer to the hangers. The cam plates are not installed on the rear hanger. Reference Fig.
Page 4
Front Equalizer (Between 1 and 2 Axles) NOTE: Support framework in accordance with manufacturer's recommendations. NOTE: There is a left hand (LH) and a right hand (RH) Triple Axle Road Armor Equalizer. The fixed arm must always face toward the rear of the trailer. NOTE: If the Correct Track system is installed, this procedure will take the longer shoulder bolt.
Page 5
Final Component Installation Place the axles into their normal operating position. Reference Fig. 3, which illustrates a roadside installation, and Fig. 4, which illustrates a curbside installation, for the following procedural steps: NOTE: When installing the nuts, use a wrench to hold the bolt heads. For Axle 1 and Axle 3, attach the leaf springs to the hangers with shoulder bolts and nuts.
Page 6
The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”). LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty. ...
Need help?
Do you have a question about the Road Armor Triple Axle and is the answer not in the manual?
Questions and answers