Pacific Laser Systems PLS 480 Operating Manual

O
PERATING
M
ANUAL
•
ON/OFF MENU
SWITCH
PLS 480
•
BATTERY DOOR
•
1/4 - 20 INSERT
IN BASE OF EACH UNIT
•
POUCH
•
FLOOR
TARGET
•
STANDARD
FLOOR BASE
•
UNIVERSAL
ADAPTER
OPTIONAL
Shown with optional
•
PLS SLD LASER
universal base tripod adapter
DETECTOR
OPTIONAL
P A C I F I C L A S E R
S Y S T E M S
The Professional Standard
Please review the PLS-SLD Laser Detector operating manual for
use with PLS 480 for exterior application.
FEATURES MENU SWITCH
ON/OFF / SQUARE LINES AND DOWN POINT
ON/OFF / LEVEL LINES
FIRST PRESS:
SECOND PRESS: OVER RIDE SELF
THIRD PRESS:
PULSE: OUTDOOR MODE TO USE WITH SLD
DETECTOR - SQUARE AND LEVEL
GREEN LIGHT:
RED LIGHT:
AMBER LIGHT:
SOLID LIGHT:
BLINKING LIGHT:
UNIVERSAL
BASE-TRIPOD ADAPTER
The universal tripod adapter is included
with the PLS 480 SYSTEM. The
adapter has two components. 1) Floor
and Batter Board Base and 2) Tripod -
Fine Tune Base. The two components
can be used separately or together
depending on the job site application.
When using your PLS480 on the floor
or concrete slab, attach the PLS480 to
the combined adapter (top and bottom
components together) by inserting its
1/4 - 20 bolt into the 1/4 - 20 insert on
bottom of the PLS480.
The reversible front foot can be turned
around by loosening the screw-bolt and
rotating to allow a straight edge against
SELF LEVELING MODE
bottom track. The fine tune adjustment
knob allows the PLS480 (or other PLS
laser) vertical lines to move incremen-
LEVELING MODE
tally right or left.
OFF
The top component also swivels right
and left for maximum utility of the laser.
•
FINE TUNING KNOB
ON
EXCEEDS TILT
BATTERY LOW
INTERIOR
TWIST OFF/ON BASE
EXTERIOR
•
REVERSIBLE FOOT
UNIVERSAL UNIVERSAL
BASE-TRIPOD ADAPTER BASE-TRIPOD ADAPTER
When using your
PLS480 on a tripod
secure the top
component of the
adapter to the
tripod stud. Secure
the PLS480 to the
adapter and posi-
tion the down point
of the laser to point
through the tripod
When using your PLS480 on
handle or cantilever
batter board attach the PLS480 to
the tool so the
the combined adapter (top and
down point can be
bottom components) and place the
seen between the
PLS480 and adapter on to the batter
tripod legs.
board. Secure the PLS480 to the batter
You can now adjust
board with the threaded clamp on back
the laser for square
of the adapter. The down beam of the
layout using the
PLS480 should project closely in front
down point as your
of the batter board. Use the adapter
spring point and
adjustable knobs to turn the square
capturing the
beams of the PLS480 (or other PLS
square laser lines
laser) right or left to meet the target
with your SLD
or SLD Detector.
Detector.