Table of Contents
Advertisement
Source connections
The RMZ-955 has four pair of RCA inputs for four source compo-
nents, as well as four pair of RCA "loop-through" outputs that
can send the source signals to other components.
Source inputs
Connect LINE LEVEL sources (CD player, tuner, etc.) to the
RMZ-955's rear panel inputs as follows.
Using shielded RCA-RCA cables, connect the source's output to
the corresponding source input on the RMZ-955. Connect analog
outputs from the source components as indicated to assure
clear operation with both the RR-952 hand held remote and the
RKP-901 keypad:
Tuner
CD player
Tape deck / DSS Satellite
CD2 / VCR / DVD / LD
Make sure to observe correct channel continuity from source to
RMZ-955. The RMZ-955's RCA inputs are labelled for easy identi-
fication with Left Channel connections on the top row and Right
Channel connections on the bottom row.
TAPE MONITOR
IN
OUT
~
1
2
L
R
IN
OUT
IN
Tuner connected to Source 1 input (with optional pass-through to preamp for shared use with separate system).
RMZ-955 Input 1
RMZ-955 Input 2
RMZ-955 Input 3
RMZ-955 Input 4
INPUTS
TUNER
CD
AUX1
AUX2
UNSWITCHED
SWITCHED
LINK
LINK
PAGING
ZONE D
INPUTS
3
4
SPEAKERS
TRIGGER
LEFT RIGHT
–
+ –
+
1 2 3 4 5 6
AUDIO IN
AUDIO OUT
OUT
IN
OUT
IN
OUT
OUTPUT
RIGHT
LEFT
INSTALLATION: RMZ-955 CONTROLLER
Note 1: The RMZ-955 does not accept a phono cartridge's output
directly. If required, use a separate phono preamp (such as
Rotel's RQ-970BX) to boost phono signal to line level.
Note 2: Use only FIXED LEVEL source outputs to the RMZ-955.
Source outputs
Each source input on the RMZ-955 has a matching pair of "loop-
through" output RCA jacks. The primary use of these "loop-
through" outputs is to pass the signal from each source
component to additional RMZ-955 controllers in large multi-zone
systems (see page 15 for details on installing large systems).
In some cases, these "loop-through" outputs may alternatively
be used to "share" the source components with a separate
home theater or audio system. If the source is shared by another
system, connect each pair of RMZ-955 source outputs to the
appropriate inputs of the main system's preamplifier as shown in
the hook-up illustration.
Note: The source sharing does not work with all combinations of
components. Specifically, home theater and audio systems with
micro-processor controlled source input switching may result in
problems such as interference or "mixing" between shared
sources.
LINE OUT
CAUTION
CAUTION
MULTI-ZONE CUSTOM CONTROLLER
RISK OF ELECTRIC SHOCK
RISK OF ELECTRIC SHOCK
DO NOT OPEN
DO NOT OPEN
MODEL NO. RMZ-955
POWER CONSUMPTION: 430W
IN
~
SPEAKER IMPEDANCE
AC120V
60HZ
4 OHM MINUMUM
OUT
DESIGNED AND MANUFACTURED
IN ENGLAND
ZONE C
PRE-OUT
PRE-OUT
SPEAKERS
SPEAKERS
LEFT RIGHT
LEFT RIGHT
DATA
DATA
–
+ –
+
–
1 2 3 4 5 6
PREAMPLIFIER
WARNING:
TO REDUCE THE RISK
OF FIRE OR ELECTRICAL SHOCK DO
NOT EXPOSE THIS EQUIPMENT TO
RAIN OR MOISTURE.
N/C
RC-5
ZONE B
ZONE A
SPEAKERS
PRE-OUT
PRE-OUT
LEFT RIGHT
DATA
DATA
+ –
+
–
+ –
1 2 3 4 5 6
1 2 3 4 5 6
TUNER
WE1
T
X
O
WE2
U
T
WE3
P
U
T
WE4
S
TX-FORMAT
+
1 2 3 4 5 6
9
Advertisement
Table of Contents
