Incon TS-LLD 1 Replacement Parts Manual

Changing the TS-LLD 1 microfarad Line Filter Capacitor
Parts Required:
1. TS-LLD Installation Manual
(INCON P/N 000-1359)
2. Line Filter Cap (LSSP-LF)
Tools Required:
1. Flat-bladed & Philips head
screwdrivers (assorted sizes)
2. Multimeter with test probes (set to read voltage at 120 VAC)
Old Line Filter – Removal Steps:
DANGER 240 V AC is present !
1.
in the TS-LLD CU Installation & Wiring and in the Safety Chapter of that manual.
2. Open / remove the submersible pump relay box cover.
3. Use the multimeter to make sure NO VOLTAGE IS PRESENT from N to any
other terminal inside the relay box.
4. Remove the old Line Filter Capacitor (INCON P/N 020-0028).
New Line Filter – Installation:
Follow the Safety
to install the new line filter
Testing (as detailed in the TS-LLD Installation Manual).
Discard the old Line Filter Capacitor
Contact INCON Technical Service Department for any additional help. Call toll free
at 1-800-984-6266.
E- m a i l : t e c h @ i n t e l c o n . c o m
s a l e s @ i n t e l c o n . c o m
I N T E L L I G E N T C O N T R O L S I N C
74 INDUSTRIAL PARK RD
Replacement Parts Instructions
N
...disconnect
Instructions, the installation steps for the new
capacitor, and the
—
F A X 1 - 2 0 7 - 2 8 2 - 9 0 0 2
F A X 1 - 2 0 7 - 2 8 3 - 0 1 5 8
h t t p : / / w w w . i n t e l c o n . c o m
SACO ME 0407 2
Install the 1uF Line Filter
Capacitor (INCON PN LSSP-LF)
Between L1 & L2
DANGER Electrical shock hazards!
Turn off and lock-out the submersible
pump power source (terminated at
L1 and L2), and the pump relay power
L1 L2
source (terminated at S2, from the
dispenser switch) BEFORE working
on this equipment. Failure to turn off
these power sources will result in
severe injury or death.
electrical power as described
After Installation Steps /
—
T E L 1 - 8 0 0 - 9 8 4 - 6 2 6 6
T E L 1 - 8 0 0 - 8 7 2 - 3 4 5 5
U S A
0 0 0 0 2 3 1 A . D O C
CU enclosure
P A G E 1 o f 1