SBL MCBRF-RGBW User Manual

Important: Read all instructions prior to installation.
RGBW LED Controller with Wireless RF Remote

Parts Included

1 - LED Controller
1 - Wireless Remote

Specifications

Dynamic Mode
Static Color
PWM Grade
White Brightness Grade
Color Brightness Grade
Speed Grade
Direct Color Select
Overload protection
Overheat protection
Working Voltage
Battery
Remote frequency
Remote control distance
Rate Output Current
IP Rating
FCC ID
Functions
1. Turn On/Standby
Press 'I' key to turn on unit or press 'O' key to turn off. At power on, unit will
automatically turn on and restore the previous settings.
2. White Mode
These two keys control white LED working mode. Press 'WHITE ONLY' key,
all RGB colors will turn off and only white LED lights up. Press 'WHITE OFF'
key, the white LED will turn off and RGB LED remains on it's previous status.
3. White Brightness
Adjust white LED brightness. Press the right side key to increase white LED
brightness and the left side key to decrease white LED brightness.
4. Static RGB Color Selection
These keys control the RGB static color.
a) Pressing the color printed keys will set the RGB LEDs to correspond color
light as the key. There are 6 shortcut color keys to make direct color selection.
b) Press 'COLOR+' and 'COLOR-' to scroll over all preset static colors,
including the 6 shortcut key colors.
5. Color Brightness
Adjust RGB color brightness. Press the right side key to increase RGB LED
brightness and the left side key to decrease RGB LED brightness.
6. RGB Dynamic Modes Control
These keys control the RGB dynamic modes.
a) Press 'MODE+' and 'MODE-' key to select preset dynamic modes.
b) Press 'SPEED+' and 'SPEED-' to control the dynamic mode running speed.
7. Remote Controller Indicator
The blue indicator will blink when remote control is transmitting a command.
The remote controller works at radio frequency. The remote controller's use is
not restricted by normal obstructions such as walls, doors, etc.
4400 Earth City Expy, St. Louis MO 63045
1 - CR2025 3V Battery
34 modes
30 colors
256 Steps
10 levels
5 levels
10 levels
6 direct keys
Yes
Yes
DC 6-24V
3V CR2025
433.92MHz
>15m at open area
3x2.5A + 4A
IP68
2ACJPRM06

User Manual

Part Number:
MCBRF-RGBW
Installing
8. Power Supply Wiring
The red power cable should be connected to power positive and black to negative.
The controller unit can work from DC 6V to 24V, Please make sure the power supply
voltage is same as the LED load and the power supply is adequite for the circuit.
9. LED Ouput Wiring
This controller supports constant voltage driving LED products with a
common anode connection. The black cable on the ouput side is the
common anode, it connects to the power supply positive inside the
controller. The white, green, red and blue cable runs the driving signal
of relevant LED color, please connect the color cable to the cathode of
relevant color LED loads and the black cable to the common anode.
10. Status Indicator
The is a full color status indicator. It displays all working statuses of the controller. It
indicates different events as following:
Blue: normal working.
Short single white flash: new command executed.
Long single white flash: reach mode or color cycle edge.
Long single yellow flash: reach speed or brightness limit.
Red flash: overload protected.
Yellow flash: overheat protected.
866-590-3533 support@superbrightleds.com