Zone Configuration - B&K p/n 12698 Owner's Manual

ZONE CONFIGURATION

Zone Configuration will allow you to set maximum volume levels for each zone, change remote control ID codes
for each zone and turn off the on-screen display overlays in zone 1. Make sure you are in the ADVANCED
SYSTEM SETUP menu and the remote is in AUDIO mode.
Z1 Max Level - Z1 max level allows you to set a maximum volume level for zone 1. This is very useful if you are
using speakers that can't handle the maximum power output from your A/V System Controller or if you simply wish
to limit the volume that can be achieved using normal front panel or remote operation.
WARNING - If you set this level too low, the A/V System Controller may appear broken (no sound).
ADVANCED SYSTEM SETUP
1 Zone Configuration
2 Power On Titles
3 Control Out
4 Security Options
SEL
M E N U
From Remote
­ V
1
(PAUSE) or (STOP)
2 SEL or ENTER
­ V
3
(PAUSE) or (STOP)
ˆ ‡
4
(REW) or (FF)
move to new line
select menu page
previous page
From Front Panel
(UP) or (DOWN)
(ENTER)
(UP) or (DOWN)
VOLUME KNOB
40
ADVANCED ZONE SETTINGS
1 Z1 Max Level +15 dB
2 Z1 Product ID 1
3 Z1 On Screen Enabled
4 Z2 Level Control Variable
5 Z2 Max Level +15 dB
6 Z2 Product ID 2
move to new line
adjust parameter
M E N U previous page
Action
move to Zone Configuration
activate ADVANCED ZONE SETTINGS
move to Z1 Max Level
set desired maximum level
p/n 12698 Rev. 9808B