Yetong YET-112 Installation Manual

WIFI One-door Access Controller
Introduction
This access control use newest microprocessors and high-speed long-life EEPROM
non-volatile memory, card reader and mobile phone APP controller integrated design, with
a simple circuit, low power consumption, simple operation, stable and reliable and
outstanding advantages.
Support opening door by mobile APP,APP can open/close door timing, countdown
open the door ; APP can manage numerous access control, managers can share
countless users and other functions, APP using WAN connection.
User Manual
1.Technical parameters
NO Item
Operating voltage
1
Static current
2
Dimensions
3
Weight
4
Ambient temperature
5
Relative humidity
6
Storage
7
Card type (alternative)
8
Card reading distance
9
2.How to set Manager Card
Step1、Turn off power and connect bin 2&3 of INI (J2) to restore factory settings
( users will not be deleted, if added)。
Step2、Turn on power and green light. now read two empty cards ,first one as
Manager Add Card and Second one as Manager Delete Card
Step3、Turn off power, disconnect bin2&3 and connect bin 1&2 of NOR。
Step4、Turn on power again.
3. How to use Manager Card – MAC&MDC
To add a card user in standby mode: read MAC
To delete a card user in standby mode: read MDC
To delete all users in standby mode: read MDC
To Recover recently deleted all user cards: read MAC
V2.5
Value
DC 12V±10%
≤10mA
U200:135mm×58mm×22mm
U200:500g;
-40℃ - 60℃
10%—90%
2000users
EM(ID) card(IC card for options)
1－15CM
read new cards read MAC
read registered cards read MDC
read MAC read MDC
read MDC read MAC
4. Installations Guide:
4.1 Wire Connection:
NO Mark Color
1 Unused Pink
2 Unused Pink Blue
3 DO Green
4 D1 White
5 Unused Grey
6 OPEN Yellow
Brown
7 D_IN
8 12V+ Red
9 GND Black
10 NO Blue
11 COM Purple
12 NC Orange
4.2 Diagram
Remark: User cards can be added or deleted continuously. If you have set a new Manager
Add Card, you can't recover recently deleted all user cards.
Function Remark
Unused
Unused
WG DATA0
WG DATA1
Unused
Exit Button
Door Contact
Power+
Power-
Relay NO output
Relay Com output
Relay NC output