Lawmate PV-RC10FHD Quick Manual

1. Name and Parts
3 4
13
12
11
10
2
1
5
9
7
8
1. Power switch 9. PIR Sensor
2. Format Button
10. Rec(Red)LED
3. Photo/Rec Switch 11. Overwrite(Bright Green)LED
4. HD/FHD Switch 12. Charging(Green)LED
5. Overwrite Switch
13. Power(Blue)LED
6. Reset Button
7. Memory Card Slot
8. USB Port
1
9. Specification
PV-RC10FHD
Built-in Camera Module
Built-in image sensor 1/3" progressive CMOS sensor
Sensor resolution 2304x1536
Sensor sensitivity 3.3 Lux @ F 2.0
Lens F/No. F 3.2
Focal Length 4mm
Angle of View 66°
Video Spec.
Algorithm H.264, JPEG
File Format MOV, JPG
Video recording mode Manual & Auto
Recoreding Capability 1920x1080 / 1280x720
Frame rate Up to 30 fps
Photo Capability 5M
Storage & I/O
Memory type Micro SD Card ( Support SDHC max.32GB)
Data interface Mini USB 2.0
Misc.
Date/Time Table YYYY/MM/DD, HH:MM:SS
Power
Power Input DC 5V
Power Consuption 250mA-390mA
Standby Consuption About 5.2mA
Standby time 8 days
Battery Input DC 3.7V / 1100mA polymers battery
Physical
Dimension 17 x 5 x 1.5 cm
Weight 110 g
5
2. Package Content
3.7V Li-ion BATTERY
BA-PV900
Li-ion
CAUTION
Slide the battery into place at approximately 15 degree to avoid
damaging the golden connectors on the units.
PV-RC10FHD
TV 1080p Remote Control Covert DVR
Quick Guide
Li-ion Battery
Adapter
LawMate, innovation never stops
®
V1.0
Memory Card
User manual
3. LED Indicators
LED Indicators Device Status
6
Solid Red LED Recording on
Red LED Blinks Once
Snapshot
Blinking Red LED
Memory Card Full
Solid Green LED
Device Charging
Solid Blue LED Power On
Blinking Blue LED No Memory Card
Solid Bright Green LED Overwrite On
2
PIR Sensor Illustration
1.Detection Range
TOP VIEW
X
2.5
8.202
19 0
1.25
4.101
2.5 5m
0 0 0
8.202 16.404ft
1.25
4.101
19 0
2.5m
8.202ft
2m 5m
5.562ft 16.404ft
SIDE VIEW
Y
2.5
8.202
1.25
11 0
4.101
2.5 5m
0 0 0
8.202 16.404ft
1.25 11 0
4.101
2.5m
8.202ft
2m 5m
5.562ft 16.404ft
2.Detection concerns
They may fail to detect successfully if a heat source other than a
human being is detected or if there are no temperature changes in or
movement of a heat source. Care must generally be taken in the
following cases. The performance and reliability of the sensors must
be checked out under conditions of actual use.
6
4. Battery Charging
1. Remove the battery cover from back.
2. Slide the battery into battery tray.
3. Close the battery tray with battery cover.
USB cable
4. Connect the USB cable to the base.
5. Plug the USB cable to the PC or other USB power
source ( the green LED will turn on ).
6. Leave the DVR charging until the green LED is turned off.
5. Format Memory Card
1. Insert the memory card as shown in the illustration.
2. Press & hold on then power on the device.
2
3. You will see the Red LED blinking when the memory card
is being formatted. The Red LED will be off when the
memory card format is completed.
<1>Cases where a heat source other than a human being is detected
(1) When a small animal enters the detection range.
(2) When the sensor is directly exposed to sunlight, a vehicle's
headlights, an incandescent light or some other source or far
infrared rays.
(3) When the temperature inside the detection range has changed
suddenly due to the entry of cold or warm air from an
air-conditioning or heating unit, water vapor from a humidifier, etc.
<2>Cases where it is difficult to detect the heat source.
(1) When an object made of glass acrylic or other subject which far
infrared rays have difficult passing through is located between
the sensor and what is to be detected.
(2) When the heat source inside the detection range hardly moves or
when is moves at high speed.
3.Installation Suggestion
Definition:
O - the height of object
H - the height of sensor
from the ground
D - the distance between
object and sensor
Formula:
H - O / 2 90CM
H
D - O x 2
For example: To film a man at 180cm height in the video, the sensor
should be placed at 90cm height above the ground and the man is 3.6m
away from the sensor.
6. Operation
1.Slide the Power switch
2. Select operation mode by sliding Photo/Rec switch
3.7V Li-ion BATTERY
BA-PV900
2.1 Rec: Whenever the PIR sensor is triggered, the DVR
Li-ion
CAUTION
Slide the battery into place at approximately 15 degree to avoid
damaging the golden connectors on the units.
automatically starts recording. Please note the length of
video varies from 5 seconds to 2 minutes depending on
the movement detection.
2.2 Photo: The device takes 3 photos whenever the PIR
sensor is triggered.
3. Resolution setting by sliding HD/FHD switch
3.1 Video resolution: HD(1280X720@30fps)
3.2 Photo resolution: 2MP(1600X1200 .JPG)
7. Download Videos and Photos from DVR
1. Video and photo files are stored in the memory card.
2. There are two ways to download video/photo files.
2.1 Using memory card reader to download video/photo files.
2.2 With the device powered on and memory card inserted,
connect the device to PC by USB connection. It will be
recognized by PC as an external drive for user to
download the video recordings and photo files.
8. Others
Please be noted that you have to turn off the device first
before you change the Photo/Rec mode.
The device may crash if you suddenly change the mode
with the power on.
3
PV-RC10FHD
TV 1080p Remote Control Covert DVR
O
180CM
D
3.6M
LawMate, innovation never stops
7
1 to the left.
3
to place.
4 to place.
FHD(1920X1080@30fps)
4
Quick Guide
®
V1.0