Outback S-Lite Quick Reference Manual

Selecting Menu Options
1 2
or
to navigate to make a
the menus selection
All S-Lite menu items are shown below.
Menu and Item Descriptions
Setup Menu
Item Description
Brightness Adjust display and LED brightness—1 (dim) to
10 (bright).
Swath Width Adjust to equal the width of the implement or
boom.
Sensitivity Adjust manual guidance indicator sensitivity
to LOW, MEDIUM, or HIGH.
Perimeter Select RIGHT, CENTER, or LEFT edge of swath
Setup width for field perimeter area calculation.
Diagnostics See "Diagnostics Menu" after this table.
Service Menu See "Service Menu" after this table.
Diagnostics Menu
Use this menu to view current settings (read-only).
3
Item
Correction
Type
Sats
STDEV
HDOP
Diff Age
Bit Error Rate
GPS Software
App Software
Serial Number
Memory
Service Menu
Use this menu to select settings.
Item
Correction
Type
SBAS Satellite
NMEA Port
Setup
Unit of
Measure
Language
Reset Defaults
Description
Type of differential correction being used—
SBAS (default) or e-Dif.
Number of GPS satellites currently visible in
the sky (not including correction satellites).
Pseudo-estimate of DGPS solution accuracy.
Valid only if six or more satellites are used in
the solution calculation.Typical values for
SBAS are 0.15 m - 0.45 m (0.5 ft -1.5 ft).
Horizontal dilution of precision indicates the
influence of the current GPS satellite
constellation geometry on the horizontal
accuracy of the position solution. Lower
HDOP values indicate better geometry. Typical
valves are 0.8 - 2.0.
Age (in sec) of RTCM corrections used in
DGPS calculation. Optimal value is < 7.
Quality of the correction data received from
SBAS satellites. S-Lite can track one or two
correction satellites and each satellite is
represented by a different BER value. The
scale of each value is 0 to 500, with 0 being
the best (highest quality signal) and 500 being
the worst. When tracking two correction
satellites the two values are separated by a
hyphen, such as 20-200.
GPS software version.
Application software version.
Serial number of your S-Lite—this should
match the number on the serial number tag
on the back of the console.
Remaining memory (in hours). All passes are
recorded in memory until erased at the end of
each field. To clear memory, press the STOP
GUIDANCE button then select Erase Memory.
Description
Select differential correction type (SBAS or
e-Dif).
Optional menu item appears only if you select
SBAS as the correction type.
Display NMEA Port Setup menu where you
set the baud rate and message update rates.
Select unit of measure (feet or meters).
Select language.
Reset factory defaults.
Outback S-Lite
Quick Reference Guide
Console Features
Steering Guide lights Headland indicator
Current
position
lights
Display
Buttons
Button Functions
Access the Setup menu
and submenus
Navigate menus
or toggle between
run screen views
Activate Contour
Guidance mode
Indicators and Displays
Signal Indicators
No Signal
GPS
DGPS
Document Part No. 875-0195-000 Rev C1
GPS signal
indicators
Buttons
Activate Straight
Guidance mode
Stop guidance/
stop logging data
Make selection
S-Lite automatically
searches for
available signals