Advertisement
1.
Assemble the cradle
Assemble the cradle by hooking up the stand into the holder.
2. Secure the radio unit into the cradle.
3. Connect the supplied USB cable to the DC jack located on the side panel of the
KADABCONVA, and into the USB jacks on the cigarette-lighter power plug. Please refer
to the Control Layout section for the side view of the adaptor.
4. Plug the cigarette-lighter power plug into the cigarette lighter of your car.
5. Install the external antenna as shown in the diagram below:
2-3mm
2-3mm
1.
Turn on the radio.
2. The unit will perform a full scan of available DAB stations automatically.
3. Press the FM TX button, then the screen will show the current FM transmitting frequency.
The default frequency is 87.5MHz, however you can change it manually so it better suits
the area that you are in.
4. Turn your car radio on.
5. Switch the car radio's FM frequency to match the transmitting frequency setting.
Reset: reset the DAB stations.
•
Volume: volume control.
•
Full Scan: start a full scan of the DAB stations.
•
Manual Scan: do manual tuning of DAB stations.
•
DC 12V Cigarette Lighter
:
Advertisement
