Beko DIN 15212 Quick Reference Manual

! Attention: Please read the operating manual prior to operating the machine for the first time.
1
On / Off Key
2
Tablet Detergent Indicator
3 Salt Indicator
4 Start / Pause / Cancel
Indicator
5 Start / Pause / Cancel Key
6
Time Delay Key
7
Time Delay Indicator
8 Rinse Aid indicator

Starting your machine

· Open the tap.
· Plug in to the socket.
· Open the door of the dishwasher.
· Place the dishes in accordance with the instructions in the
user manual.
· Make sure that the upper and lower impellers rotate freely.
· Put sufficient amount of detergent in the detergent dispenser
and close its lid.
· Make sure that indicators on programme display are
illuminated by pressing On / Off key.
· Check if the Salt and Rinse Aid indicators light and add salt
and / or rinse aid if needed.
Since different salt brands in the market have different
particle sizes and since the water hardness may vary,
dissolution of the salt in water may take a couple of hours.
Therefore, Salt Indicator remains on for a while after adding
salt into the machine.
· You may use Half Load / Tablet Detergent Key and Time
Delay key features as necessary.
· Refer to "Table of Programme Data and Average
Consumption Values" to select a suitable programme.
Programme number
Programme name
Cleaning temperature
Degree of Soiling
Detergents
A=25 cm³/15 cm³ B=5 cm³
Programme sequence
(without options)
Duration (min)
Water (I)
Energy (kWh)
The consumption values shown in the table were determined under standard conditions. Differences may therefore occur under practical conditions.
* Reference programme for testing institutes The tests in accordance with EN 50242 must be carried out with a full water softener salt dispenser and a full rinse aid reservoir, and using the test programme.
QUICK REFERENCE GUIDE
9 Half Load Indicator
10 Programme Indicator
11 Half Load / Tablet
Detergent Key
12 Programme Selection Key
1 Reference*
50°C
Most economical washing Suitable for removing the remnants
program for the medium soiled on the soiled dishes that will be kept
daily dishes that are kept waiting. waiting in the machine for a few
days, and thus, for preventing the
bad odor buildup.
Medium
A+B
Pre-wash
▼
Wash
▼
Cold rinse
▼
Hot Rinse
▼
Dry
▼
End
190
12
1,02
· Select the desired programme with Programme Selection key.
· Press Start / Pause / Cancel key to start the programme.
Pay attention not to open the door of the machine when it is
running. If you need to open the door, safety system will stop
your machine. There may be a rush of vapour when you open
the door of your machine; be careful. The programme will
resume running when you close the door.
· When the programme you have selected comes to an end, an
audible warning signal with intervals of 8 seconds will warn you
to turn off your machine. This audible signal will warn you 10
times before it turns off.
· Open the door of the dishwasher.
· Press On / Off key to turn off your machine.
· Indicator lights on the programme display will turn off.
· Close the tap.
· Unplug the machine from the socket.
Leave your dishes in the machine for about 15 minutes after
they are washed in order to have them cooled down. Your
dishes will dry in a shorter time if you leave the door of your
machine ajar during this period. This will increase the drying
effectiveness of your machine.
Programme Table
2 3
Intensive Daily
70°C 65°C
Suitable for lightly soiled daily
dishes that are scraped or pre-
cleaned.
- Few
- A
Pre-wash Wash
▼ ▼
End Cold rinse
▼
Hot Rinse
▼
End
124 96
17,6 10,6
1,7 1,04
4
Quick&Clean
70°C
Daily washing program at which the Suitable for heavily soiled dishes,
medium soiled dishes that are kept
waiting are cleaned in the fastest way.
Medium
A+B
Wash
▼
Cold rinse
▼
Hot Rinse
▼
Dry
▼
End
58
11,8
1,32
EN
Reset
3 sec.
Reset
3 sec.
5
30min.
35°C
pots and pans.
High
A+B
Pre-wash
▼
Cold rinse
▼
Hot Rinse
▼
Hot Rinse
▼
Dry
▼
End
30
11,8
0,79