Before you switch on Plug in and switch on Temperature control Your wine cooler should not be installed on a The wine cooler runs on an electricity supply electronic temperature controller displaying current internal carpet, this may prevent sufficient air of 220-240 V 50Hz and must be earthed.
After replacing the shelves, plug in and nominal charge from: electrical supply and switch on. switch on the mains supply. Spares Department, Lec Refrigeration plc, Bognor Regis, West Sussex, P022 9NQ Take care to avoid the light and the electronic Tel 0870 1120208.
Useful hints Troubleshooting If your appliance is to be out of service for any your wine cooler rattles damaged door seal or the door is not aligned length of time ensure that the interior is properly (an uneven gap can be seen above carefully cleaned and dried.
Should you sell or pass the Lec wine internally or defrosting. of your old appliance and packaging from Lec wine cooler. If not, contact the Customer...
Page 6
• The wine cooler has been treated in an abnormal or abusive manner • The wine cooler has been used for industrial or commercial purposes. • Any repair work has been carried out by any person other than a Lec approved engineer.