Hobbywing WP-10BL50-RTR User Manual

Hobbywing WP-10BL50-RTR User Manual

Water-proof sensorless brushless speed controller ( rtr version )

Advertisement

Quick Links

User Manual of Water-Proof Brushless Speed Controller (RTR Version)
USER MANUAL
WATER-PROOF
SENSORLESS BRUSHLESS
SPEED CONTROLLER
( RTR VERSION )

【DECLARATION】

Thanks for purchasing our electronic speed controller (ESC). The power system for RC model can be very
dangerous, so please read this manual carefully. In that we have no control over the correct use,
installation, application, or maintenance of our products, no liability shall be assumed nor accepted for
any damages, losses or costs resulting from the use of the product.

【FEATURES】

1.
Water-proof and dust-proof. The ESC can work under water for a short time.
(Please remove the cooling fan when running car in water, and after running, please make the ESC
clean and then dry it to avoid the oxidation to copper connectors)
2.
Specially designed for RC car and truck, with excellent start-up, acceleration and linearity features.
3.
Drive sensorless brushless motors.
2 running modes ("Forward with brake" mode, "Forward/Backward with brake" mode).
4.
5.
Proportional ABS brake function with 4 steps of maximum brake force adjustment, 8 steps of drag-brake force
adjustment.
4 start modes ("Punch") from "Soft" to "Very aggressive" to be suitable for different chassis, tires and tracks.
6.
7.
Multiple protection features: Low voltage cut-off protection for Lipo or NiMH battery / Over-heat protection /
Throttle signal loss protection / Motor blocked protection.
Easily programmed with the "SET" button on the ESC or with the LED Program Card.
8.

【SPECIFICATIONS】

Model
WP-S10C-RTR
WP-S16-RTR
Cont./Burst
25A/90A
45A/260A
0.005 ohm
Resistance
0.0012 ohm
1/18,1/16 scale
Car Applicable
On-road: ≥12T
On-road: ≥9T
2S Lipo
6 cells
Off-road: ≥18T
Off-road: ≥12T
NiMH
Motor
2040 size motor
3650 size motor
On-road: ≥18T
On-road: ≥12T
Limit
3S Lipo
9 cells
Off-road: ≥24T
Off-road: ≥18T
NiMH
2040 size motor
3650 size motor
Battery
4-9 cells NiMH or 2-3S Lipo
5V*
Rating Voltage of
Without cooling
the Stock Cooling
fan
* The stock 5V cooling fan only works with 2S Lipo or 4-6 cells NiMH.
Fan (*Note 1)
When using 3S Lipo or 7-9 cells NiMH, the stock 5V cooling fan MUST
Built-in BEC
6V/1A
Program Port
Rx Wire
Dimension/Weight
36*28*21 / 38g
49*34*35/ 75g
* Note1: Please remove the cooling fan when running the ESC in water. For more information about the 12V
cooling fan, please refer to the brief
introduction on page 3.

【BEGIN TO USE THE NEW ESC】

1. Connect the ESC, motor, receiver,
battery and servo according to the
following diagram
"+" and "-" wires of the ESC are
connected with the battery pack, and #A,
#B and #C are connected with the motor
wires. The "SET" button is used for
programming the ESC.
The control cable of the ESC (trio wires
with black, red and white color) is
connected with the throttle channel of the
receiver (Usually CH2).
1The #A, #B, #C wires of the ESC can be
connected with the motor wires freely
(without any order). If the motor runs in
HW-SM601ENG-20140903 Page - 1 -
WP-S10D-RTR
WP-S10DS-RTR
WP-10BL50-RTR
WP-S10E-RTR
WP-10BL60-RTR
50A/300A
60A/390A
45A/220A
0.0010 ohm
0.0007 ohm
0.0012 ohm
1/10 scale on-road and off-road
On-road: ≥8T
On-road: ≥5.5T
On-road: ≥9T
Off-road: ≥11T
Off-road: ≥9T
Off-road: ≥12T
3650 size motor
3650 size motor
3650 size motor
On-road: ≥11T
On-road: ≥8.5T
On-road: ≥12T
Off-road: ≥14T
Off-road: ≥13T
Off-road: ≥18T
3650 size motor
3650 size motor
3650 size motor
WP-S10D-RTR: 5V*
7.4V
WP-S10DS-RTR: 5V*
7.4V
WP-10BL60-RTR:7.4V
be replaced by 7.4V or 12V cololing fan.
6V/2A
Multiplexed with cooling fan port
WP-S10D-RTR:
49*34*35 / 75g
WP-S10DS-RTR:
48.5*38*32 / 90g
48.5*38*32 /90g
49*32*41 / 75g
WP-10BL60-RTR:
48.5*38*32 / 90g

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WP-10BL50-RTR and is the answer not in the manual?

Questions and answers

Summary of Contents for Hobbywing WP-10BL50-RTR

  • Page 1 Throttle signal loss protection / Motor blocked protection. Easily programmed with the “SET” button on the ESC or with the LED Program Card. 【SPECIFICATIONS】 WATER-PROOF WP-S10D-RTR Model WP-S10C-RTR WP-S10DS-RTR WP-S16-RTR WP-10BL50-RTR WP-S10E-RTR WP-10BL60-RTR SENSORLESS BRUSHLESS Cont./Burst 25A/90A 45A/260A 50A/300A 60A/390A 45A/220A 0.005 ohm...
  • Page 2 User Manual of Water-Proof Brushless Speed Controller (RTR Version) HW-SM601ENG-20140903 Page - 2 - the opposite direction, please swap any two wire connections. Over-heat protection: When the temperature of the ESC is over a factory preset threshold for 5 seconds, the ESC will cut off the output power.
  • Page 3 User Manual of Water-Proof Brushless Speed Controller (RTR Version) HW-SM601ENG-20140903 Page - 3 - disconnect the Rx wires from receiver and then connect it to LED program card. 2. Programmable Items list  For WP-S10C, WP-S10D, WP-S10DS, WP-S10E, WP-10BL60 ESC, the program port is multiplexed with the Programmable Value Programmable cooling fan port, please disconnect the cooling fan, and then use program cable to connect the fan port of the...

This manual is also suitable for:

Wp-s10e-rtrWp-s16-rtrWp-s10c-rtrWp-s10d-rtrWp-s10ds-rtrWp-10bl60-rtr

Table of Contents

Save PDF