Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for WTI RMM Series
Summary of Contents for WTI RMM Series
-
Page 1: Quick Start Guide
WTI Part No.: 14517 Rev.: A RMM Series Rack Mount Modems Quick Start Guide... -
Page 2: Input Supply
Warnings and Cautions: Installation Instructions Secure Racking If Secure Racked units are installed in a closed or multi-unit rack assembly, they may require further evaluation by Certification Agencies. The following items must be considered. 1. The ambient within the rack may be greater than room ambient. Installation should be such that the amount of air flow required for safe operation is not compromised. -
Page 3: Hardware Installation
RMM User’s Guide, which can be found on our web site at the address below, or by scanning the QR Code to the right. http://www.wti.com/uguides Hardware Installation 2.1. Apply Power to the RMM Refer to the safety precautions listed at the beginning of this Quick Start Guide and to the power rating nameplate on the RMM unit, and then connect the unit to an appropriate power source. - Page 4 RMM Rack Mount Modems; Quick Start Guide Figure 1. DB25F Modem Port (DCE) Figure 2. DB9F Modem Port (DCE) Figure 3. RJ45 Modem Port (DCE) Not Used Not Used RING Not Used Not Used Figure 4. RJ11 Phone Line Port Page 4...
-
Page 5: Commonly Used At Commands
"AT" prefix must preceed each command. Refer to the list of commonly used AT commands in Section 2.2.3 below, or refer to the MT5634/MT9234 Internal Modem AT Command Set document that can be found on the WTI web site at: https://www.wti.com/t-product-manuals.aspx 2.2.3. -
Page 6: Operation
The RMM offers three Modem Serial Ports that can be used to connect the Modem to a target device such as a server or switch. The pinout of the three Modem Ports allows connection to most Cisco and WTI devices. When connecting to the Modem Port, note the following: Note: Only one Modem Port can be connected at a time. -
Page 7: Fcc Part 15 Regulation
RMM Rack Mount Modems; Quick Start Guide FCC Part 15 Regulation This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. - Page 8 5 Sterling • Irvine • California 92618 (949) 586-9950 • Toll Free: 1-800-854-7226 Fax: (949) 583-9514 • http://www.wti.com...
Need help?
Do you have a question about the RMM Series and is the answer not in the manual?
Questions and answers