DataON DNS-1640 User Manual

2u 24 bays 6gb/s sas jbod dual-path, dual i/o

Hide thumbs

Table Of Contents

DNS-1640

2U 24 Bays 6Gb/s SAS JBOD

Dual-path, Dual I/O

User Manual

Version QS0003

www.dataonstorage.com

Table of Contents

Summary of Contents for DataON DNS-1640

Page 2 Neither this manual, nor any of the material contained herein, may be reproduced without the express written consent of the manufacturer. Copyright © 2011 DataON Storage Inc. Trademarks All product names used in this manual are the properties of their respective owners and are acknowledged.
Page 3: Package Content
• CD with user manual and drivers (1) • Universal Rail Kit for DNS-1640 (1) • HDD Screws(96) System requirements • Servers with supported HBA/Raid adapter, refer to DNS-1640 support matrix reference for complete listing of supported adapters. • SFF-8088 to SFF-8088 SAS cable(s). Model...
Page 4: Dns-1640 Overview
DNS-1640 User Manual DNS-1640 Overview LEDs on the Storage Enclosure Component Color Lights On Lights Off Fault LED Amber A component within the storage en- Normal closure needs attention. Locate LED Flashing Blue Identifies a storage enclosure Normal Power Green...
Page 5: Dns-1640 (Single Sim) Rear View
DNS-1640 User Manual DNS-1640 (Single SIM) Rear View SAS #2 SAS #1 SAS #3 Board #1 Connector Connector Connector Power Supply Power Supply Module 1 Module 2 Power Connector DNS-1640 (Dual SIM) Rear View Board #2 Board #1 SAS #2...
Page 6 DNS-1640 User Manual DNS-1640 SIM Board LED Description LED ON SIM Board Consoles for factory use only Component Color Lights On Lights Off SAS #2 Fault Amber PHY connection cannot estab- No error had occurred lished correctly SAS #2 Active...
Page 7: Dns-1640 Psm Board Led Description
DNS-1640 User Manual DNS-1640 PSM Board LED Description Component Color Lights On Lights Off DC Power Green DC Power On No DC Power Locate LED Blue Identifies Power Module Normal PSM Fault Amber Fault exist Normal AC Power Green AC Power On...
Page 8: Disk Drives Front Led And Tray
DNS-1640 User Manual Disk Drives Front LED and Tray Optional DNS-BJMB 9252 6Gb/s SAS Interposer for 2.5” HDD Tray SATA SSD/HDD Release button Disk Tray Handle Component Color Description HDD Activity LED Solid Green SAS HDD is ready (SATA will be blank)
Page 9: Install/Replace Hdd
Install/Replace HDD Before You Begin It is not recommend mixing different RPM SAS and SATA HDD in the same DNS-1640 system. If you have to, please use the following figures below to plan where you will be placing the disk drives.
Page 10 DNS-1640 User Manual Follow these steps below to Install/Replace HDD in the disk tray. Step 1 a) Press the release button and open the disk tray handle. b) Remove HDD carrier by pulling the disk tray handle out.
Page 11 DNS-1640 User Manual Step 2 Insert the HDD inside the tray and tighten the four 6/4 screws on the SATA/SAS disks. SATA disk SAS disk Interposer for SATA Important: If using SATA HDD, please make sure having DNS-BJMB Interposer card installed...
Page 12 DNS-1640 User Manual Step 3 Slide in the HD tray back in the disk slot and close the disk tray handle. Step 4 Repeat Step 1 through 3 if you wish to install more HDD into the DNS-1640 storage.
Page 13: Before You Begin
If necessary refer to the documentations shipped with the 6Gb/s SAS HBA/RAID card for hardware and driver installation instructions There are different types of SAS Cables in the market, make sure you order the right one for DNS-1640. For DNS-1640, it all uses SFF-8088 to SFF-8088 SAS Cable when connecting DNS-1640 to host and when daisy chain to another DNS-1640.
Page 14: Setting Up Dns-1640 System
DNS-1640 User Manual Setting up DNS-1640 System Connection type 1(Single SIM) This illustration shows one host with a HBA/RAID card connected to four DNS-1640 with single SIM. SFF-8088 to SFF-8088 SAS Cable DNS-1640 DNS-1640 DNS-1640 DNS-1640...
Page 15 DNS-1640 User Manual Connection type 2(Dual SIM) This illustration shows one host with a HBA/RAID card connected to four DNS-1640 with dual SIM. Not All HBA/RAID card support this type of connection please refers to DNS-1640 Important: support matrix reference for complete listing of supported dual port HBA/RAID cards.
Page 16: Connecting Power To Dns-1640
DNS-1640 is recommended to be installed in Dual power strip cabinets. 1. Ensure the cabinet circuit breakers are in OFF position. 2. Connect the two provided power cables from the DNS-1640 to cabinet power strips. 3. Lock down the two power cord latch.
Page 17: Power On The Dns-1640
Power on the DNS-1640 1. Verify that all connections are correct. 2. Turn on both circuit breakers on cabinet. 3. Make sure that power-on LED on all DNS-1640 are steady blue. 4. Power on the host lastly. Important: Please make sure power on all DNS-1640 first before the server...
Page 18: Features And Specifications
Support full path fail-over function which pro- terposer card. In addition to 24 pcs hard drive vides data redundancy carriers, DNS-1640 system supports two 550W Support Drive Auto Detection and Hot Swap Full Redundant Power Supplies and two SIM Integrated RAID card management tool via modules.
Page 19 DNS-1640 User Manual Host I nterface: AC Pow er: Two 6Gb/s SAS-In ports on each SIM module Input Voltage: 100-240 V AC   One 6Gb/s SAS-Out ports on each SIM module Input Frequency: 50-60Hz   Output Power: 550W ...

This manual is also suitable for:

Dns-1640d Dns-1640sm Dns-1640dm Dns-1640s