Table of Contents
Advertisement
Quick Links
Check out what else you can get from Martindale:
•
17th Edition Testers
•
Accessories
•
Calibration Equipment
•
Continuity Testers
•
Electricians' Kits
•
Environmental Products
•
Full Calibration & Repair Service
•
Fuse Finders
•
Digital Clamp Meters
•
Digital Multimeters
•
Labels
•
Microwave Leakage Detectors
Martindale Electric Company Limited
Metrohm House, Penfold Trading Estate, Imperial Way, Watford WD24 4YY, UK
Tel: +44(0)1923 441717 Fax: +44 (0)1923 446900
E-mail: sales@martindale-electric.co.uk
Website: www.martindale-electric.co.uk
© 2014 Martindale Electric Company Ltd.
Registered in England No. 3387451. E. & O.E. LITDT85 Document Rev1
•
Motor Maintenance Equipment
•
Multifunction Testers
•
Non-trip Loop Testers
•
Pat Testers & Accessories
•
Phase Rotation Testers
•
Proving Units
•
Socket Testers
•
Thermometers & Probes
•
Test Leads
•
Voltage Indicators
•
Specialist Metrohm Testers (4 & 5kV)
•
Specialist Drummond Testers
DT85
DIGITAL THERMOMETER
Instruction
Manual
Advertisement
Table of Contents
Related Manuals for MARTINDALE DT85
Summary of Contents for MARTINDALE DT85
- Page 1 Check out what else you can get from Martindale: DT85 DIGITAL THERMOMETER • • 17th Edition Testers Motor Maintenance Equipment • • Accessories Multifunction Testers • • Calibration Equipment Non-trip Loop Testers • • Continuity Testers Pat Testers & Accessories •...
-
Page 2: Table Of Contents
Specifi cation ALWAYS READ THESE INSTRUCTIONS BEFORE PROCEEDING DT85 Thank you for buying one of our products. For safety and a full Digital thermometer understanding of its benefi ts please read this manual before use. Technical support is available from 01923 441717 and GENERAL support@martindale-electric.co.uk. -
Page 3: Safety Information
Specifi cation 1 SAFETY INFORMATION DT85 Digital thermometer REMEMBER: SAFETY IS NO ACCIDENT These instructions contain both information and warnings that are necessary for the safe operation and maintenance of this product. It is recommended that you read the instructions carefully and ensure that the contents are fully understood. -
Page 4: Precautions
The Martindale DT85 must only be used by a skilled and competent Martindale authorised resellers shall extend this warranty on new and person who is familiar with the relevant regulations, the safety risks... -
Page 5: Introduction
2. INTRODUCTION There are no user serviceable parts in this unit other than those that may be described in section 4. Return to Martindale Electric if faulty. 2.1 Inspection Our service department will provide a quotation to repair any fault Examine the shipping carton for any sign of damage. -
Page 6: Operation
Martindale Electric recommends that it is returned at least once a year to an approved Calibration Laboratory for recalibration and certifi cation. Auto power off is active Martindale Electric is pleased to offer you this service. Please contact our Service Department for details. Indicates low batteries Email: service@martindale-electric.co.uk... -
Page 7: Power On/Off
2 seconds. Indicates press of button required Relative function is active 3.10 Hold Mode The DT85 has the facility to display the maximum reading, the ENTER MODE Indicates press of button required minimum reading, the difference between maximum and minimum readings and the average of the recorded readings. - Page 8 MODE Press to advance to the next function. The maximum temperature measurement of the DT85 is 1372°C (2501°F), but the thermocouple probe being used may be specifi ed Temperature Scale to a lower temperature. Be sure that the thermocouple probe is The LCD will display SEt Unit.