Zeus T1 Quick Start Manual

User guide.ai User guide.ai 1 1
T1
WIRELESS EARBUDS
C
M
Y
CM
MY
CY
CMY
K
Quick Sart Guide
21/7/17 21/7/17 2:26 PM 2:26 PM
1. Charging your T1 Earbuds
To charge the earbuds, place them into
the slots of the portable charging case.
The white LED light on each earbud turns
on to indicate charging and turns off
when completely charged, a full charge is
approximately 45 minutes. The portable
charging case provides up to 4 additional
charges for your earbuds.
Note: Kindly remove the protective labels on the
charging contacts of each earbud for initial charging.
2. Charging your Portable Charging
Case
Plug in the small end of the micro USB
cable into the port located right below the
hinge of the case lid and connect the other
end to any USB outlet power source*.
During charging, the blue LED light on the
portable charging case starts blinking at
an interval of 2 seconds to indicate:
1~25% charged capacity = blinks 1 time
26~50% charged capacity = blinks 2 times
51~75% charged capacity = blinks 3 times
76~99% charged capacity = blinks 4 times
And stops blinking when fully charged.
*USB charger is not included in this package
and available for purchase separately.
3. Connecting Both Earbuds
Stereo audio mode provides the most
immersive music experience.
1. Remove the earbuds from the portable
charging case - the earbuds turn
themselves on and enter pairing mode by
default.
2. Enter pairing mode on the intended
smartphone/tablet/computer (refer to
your device's user guide for instructions).
4. Select the "Zeus T1" earbuds from the
list of devices detected.
5. Enter the PIN 0000 indicated on
screen to complete the process (this
process may be automatic in most
devices).
6. The Bluetooth LED indicator stops
blinking to indicate that the process is
complete and the pairing is successful.
Note: The L channel earbud is used by default for
making and receiving calls. Both earbuds are
symmetrically designed and you can choose to
swap over should you prefer to take calls on the
right.