Read this manual before powering or installing the Outdoor ViroSphere, follow the safety precautions listed below and observe all warnings in this manual and on the Outdoor ViroSphere. If you have questions about how to operate the Outdoor ViroSphere safely, please contact your Martin Architectural dealer or call the Martin Professional 24-hour service hotline at +45 70 200 201 (or in the United States at 888-TECH-180).
Warning Ensure that the Outdoor ViroSphere is not dropped as it can be easily damaged. Inst al lat ion This section describes in general terms how to mount the fixture and connect it to an amplifier. These procedures shall be performed by qualified professionals.
Page 5
Mounting holes are located at the four points of a square located inside a 200 mm diameter circle from the center of the Outdoor ViroSphere. A mounting bracket can be attached using four M10 x 25 screws and rubber spacers (to prevent vibration during operation).
Page 6
The Outdoor ViroSphere is supplied with a 6 m (20 ft) cable. When the speaker is used in an outdoor configuration, this cable must be connected to an appropriate IP-rated junction box, that is in turn connected to the amplification system.
Page 7
The audible result is a decrease in the output from the Outdoor ViroSphere. If this happens, do not increase the high frequency level on the EQ or the tone control on the mixer, as this might cause damage to the panel.
Page 8
O r d e r i n g i n f o r m a t i o n Outdoor ViroSphere....... . P/N 93723002...