DAP Technologies M4000 Series Quick Start Manual

Contents
M4010
USB Client Cable
Headset
Installing Memory Cards & the Battery
1. Open the Velcro strap and slide it out
of the unit as shown.
5. Using a T8 Torx driver, remove the four
screws holding the end cap to the unit.
9. Place the end cap on the unit, insert
the screws into their holes, and tighten
those screws using a T8 Torx driver.
Battery
Power Cord
M4020
AC Adapter
Quick Start Guide
B
A
A
2. Twist the battery cover locks (A) to
unlock the battery cover, then lift the
battery cover (B) off.
SD Card
Slot
6. Note the locations of the SD Card slot
and the SIMM Card slot.
10. Reinsert the Velcro through the unit
bracket and secure.
M4000 Series
Overview
LCD Touchscreen
Scan
Keys
Keypad
Power Input
I / O Port
Battery Cover Locks
3. Insert the battery as shown with the label
side facing up.
SIMM Card
Slot
7. Insert the SD Card into the slot with the
mitered corner to the right as shown and
press in until it locks in place.
11. Insert the AC adapter into the power
input.
PN: 778-00002 • February 2011
Quick Start Guide
Scanner LED Indicator
Scan
Keys
Power
Button
Power Input
I / O Port
Speaker
Left Scan Key
4. Replace the cover and twist the locks
closed as shown.
8. Insert the SIMM Card into the slot with
the mitered corner to the left as shown
and press in until it locks in place.
USA
12. Insert the power cord into the wall outlet
and charge the battery for a minimum of
6 hours.
LCD Touchscreen
Power
Button
Keypad
Barcode
Scanner
Headset
Jack
EU