info-hold MP-3000 M Installation Manual

1. The MP3000 M is preloaded with the
programming software and pre-programmed
with several of the 24 starter messages. If you
would like to make any programming
changes, please refer to the Programming
Guide. Please give the enclosed Certificate
[FIG 2] along with the Programming Guide
to the person who has signed the Certificate
for their
records.
FIG 2
2. Locate the included MOH cord (Qty 1)
[FIG 3]
3. Insert one end of the MOH cable into the MOH port
located on the phone system. [FIG 3] If you can not locate the
MOH port on your telephone system, please contact your
telephone vendor for location.
4. Insert the other end of the MOH cord into either
the 8Ω or 600Ω output jack located on the back
of the MP-3000 M player until it clicks in place.
Depending upon the required impedance, use
either the 8Ω or 600Ω output RCA jack, not both.
[FIG 4]
MP-3000 M Installation Guide
Please note the contents included with your MP-3000 M
on-hold player shipment. [FIG 1]
FIG 1 - Contents of MP-3 3 000 M Install Package
FIG 3
Power Cord
MP-3000 M MOH Unit
MOH Cable
USB Stick
FIG 4
Certificate
MOH
FIG 3