Advertisement
GM PASSLOCK II & PASSKEY III INTERFACE MODULE
Fig:A
Programming Position
A
B
(LED)
Fig:B
Operating Position
A
B
(LED)
IMPORTANT:
DO NOT CONNECT VIOLET
DATA OUTPUT WIRE OF INTERFACE MODULE
TO VEHICLE DATA WIRE (PIN 2) UNTIL EVERY
OTHER WIRE HAS BEEN CONNECTED & THE
HARNESS HAS BEEN PLUGGED INTO THE
DATA BUS INTERFACE (DL) MODULE.
INSTALL 2
GM PASSKEY3 (Pk3)
P a s s -K e
y II I
M o d u le
REMOTE START
MODULE
INSTALL 3
GM PASSKEY3 (Pk3)
DB-PASS-23A Installation Instructions
P a s s -K e
y II I
M o d u le
REMOTE START
BROWN - CONNECT TO (-) IGNITION OUTPUT WIRE OF REMOTE START SYSTEM
MODULE
INSTALL 2 PROGRAMMING
When the DB-PASS-23A harness is correctly installed:
Place the programming jumper to the "PROGRAMMING" position. (See
Place key in ignition and t
urn to the "ON" position.
The LED will blink 4 times to confirm sucessful programming.
Turn key to the "OFF" position.
Remove the programming jumper and put it to
TECH NOTES:
*Vehicles with the ignition cylinder located on the dash: Yellow, Black & White wires can be
found coming from the ring of the cylinder - Trace these wires to the factory PK3 module located just abov
the gas pedal area.
BLACK - CHASSIS GROUND
ORANGE - +12 VOLTS CONTANT
PINK - IGNITION IN
PINK/TRACER - IGNITION OUT
VIOLET - N/C
VIOLET/TRACER - N/C
BLUE - FUEL ENABLE LINE
GREEN - N/C
BROWN - CONNECT TO (-) GROUND OUTPUT
WHEN RUNNING WIRE OF REMOTE START SYSTEM
NO PROGRAMMING NECESSARY
INSTALL 3:
NOTE: PLACE JUMPER AS SHOWN IN FIG:E BEFORE CONNECTING MODULE.
CHASSIS GROUND
ORANGE - +12 VOLTS CONTANT
VIOLET - DATA TO ECM
VIOLET/TRACER - N/C
GREEN - N/C
Programming Jumper
"OPERATING"
TO ECM SIDE
GREY
CONNECTOR
RED - N/C
DB-PASS-23A
Programming Jumper
NOT USED
SEE FIG. E
Programming LED
N.C
GREY
CONNECTOR
BLACK -
RED - N/C
PINK - NC
PINK/TRACER - NC
BLUE - N/C
Programming LED
FIG:A)
position -
(See FIG:B)
JUMPER POSITION
Unscrew cover of DB-PASS-23A unit.
Place jumper as seen below:
Fig:E
BLACK
ORANGE
VIOLET
PINK
TO ECM SIDE
Advertisement
