Petrainer PET910 Operation Manual

a. Turn on/off the Remote Transmitter and the Training Collar(please refer to brief
introduction or How to set the Training Collar to work with a Remote Transmitter)
b. Press the Mode Button to choose V or S mode as your needs.
For V mode vibration mode, there are 9 intensity levels. Please use UP/Down Button
to adjust them.
For S mode Static Mode, there are 9 intensity levels. Please use UP/Down Button to
adjust them.
c. Press Transmitter button Y to send the signal to the Collar Receiver
Operation manual between Remote transmitter and
the Remote Beeper
Before use, please make sure you already encode the Remote Transmitter with the
Remote Beeper, and also choose the right channel.
d. Turn on/off the Remote Transmitter and the Training Collar(please refer to brief
introduction or How to set the Remote Beeper to work with a Remote Transmitter)
e. Press the Mode Button to choose R, T or L mode as your needs, and then press
Transmitter button to send the confirmation signal to the Remote Beeper.
For R mode There are 3 Running Modes. You have three choices of how often the
beeper sounds off when your dog is moving.
1. Silence Mode the Beeper will keep Silence when the dog moves and when it stops,
it will beep every 2 seconds
2. 5 Second Mode The Beeper will beep every 5 seconds when the dog moves and
when it stops, it will beep every 2 seconds
3. 10 Second Mode - The Beeper will beep every 10 seconds when the dog moves and
when it stops, it will beep every 2 seconds
For L Mode The Location Mode will disable the Remote Beeper Functions and at this
Mode, you could press the Transmitter button to send the signal to the Remote Beeper
and the Remote Beeper will play the beeper sound by which you know where the dog is.
For T Mode The Tone Mode could adjust to 9 different Tone sounds.
You could change the Remote Beeper to the different tone sound at any time you like.
Please press Mode button and change to Tone Mode. Use UP/Down Button to change to
the preferred tone sound. Once decided, press Transmitter button Y to send the
confirmation signal to the Remote Beeper.
The Remote Beeper will play the selected sound
Mode Tone
1 Beep
1
2 Whistle
3 Bird
3 Beeps
4
5 Cricket
6
Starling
Hawk
7
8 Hawk
Eagle
9
Frequence: 433. 825MHz
Remote Transmitter: 7.2V 210mAh Ni-MH
Training Collar: 3.7V 230mAh LiP
Remote Beeper: 3.7V 230mAh LiP
Please put the Training Collar and The Remote Beeper as the picture
showed on your dog.
R&TTE
Remote Beeper
Please read the entire guide before beginning
Training Collar