Advertisement
Quick Links
K T TECH
T M
KT-3128
DIGITAL DUAL ALARM FM CLOCK RADIO
I NSTRU CTI O N M ANUAL
Thank you for buying a LENOXX product.
Read this manual carefully to get the best
performance form this unit.
Lenoxx
Lenoxx Electonics Aust Pty Ltd
6 Oban Court Laverton, Vic 3026, Aus
www.lenoxx.com.au
Customer service 1300 666 848
STO RE FM RADIO STATIONS
You can store up to 20 FM radio stations in preset channel
automatically or manually.
STORE FM RADIO STATIONS AUTOMATICALLY (AUTO SCAN)
1. Press
to turn on FM radio.
2. Press
and hold for 2 seconds.
Ø The received stations are automatically stored to preset
numbers.
STORE FM RADIO STATIONS MANUALLY.
1. Tune to an FM radio station.
2. Press MEMORY to activate the storing mode.
3. Press TUNING 〈〉 to select the preset number.
Ø [P 01 ~ P 20] is preset station numbers.
Ø If this position is occupied, the previous stored frequency
will be displayed ;
Ø To remove a pre-stored FM radio station, store another
station in its place.
LISTEN TO A PRESET F M RADIO STATION
In FM mode, press MEMORY to select a preset number.、
Note:
The digit display return to clock display if no buttons is
pressed for 10 seconds
SET ALARM TIM E R
Make sure that you have set the clock correctly.
sound,
You can set two separate alarm timers. For the alarm
you can select the FM radio or the buzzer.
1. Press
to Clock mode.
2. Press and hold AL1/AL2 for two seconds.
4
IMPO RTANT
· Read these instructions.
· Heed all warnings.
· Follow all instructions.
· Do not block any ventilation openings, Install in
accordance with the manufacturer's instructions.
· Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
· Protect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the
point where they exit from the clock radio.
· Only use attachments/accessories specified by the
manufacturer.
· Unplug this clock radio during lightning storms or when
unused for long periods of time.
· Refer all servicing to qualified service personnel.
Servicing is required when the clock radio has been
damaged in any way, such as power supply cord or plug is
damaged, liquid has been spilled or objects have fallen into
the clock radio, the clock radio has been expose to rain or
moisture, does not operate normally, or has been dropped.
· This clock radio shall not be exposed to dripping or
splashing.
· Do not place any sources of danger on the clock radio
(e.g. liquid filled objects, lighted candles).
· Where the plug of the Direct-Plug-in Adaptor is used as
the disconnect device, the disconnect device shall remain
readily operable.
· Attention should be drawn to the environmental aspects of
battery disposal. Don't throw used batteries in dustbin.
Please contact your retailer in order to protect the
1
Ø [0:00] is blink.
3. Press HOUR / MINUTE to set alarm time.
4. Press AL1/AL2 to confirm.
5. Press AL1 / AL2 again to select a sound source : FM orBuzzer.
Ø The current FM radio frequency is blink if FM radio
source is selected and AL1 / AL2 indicator is light up.
Ø [bb] is blink if the buzzer sound is selected and
AL1 / AL2 indicator is light up.
Ø [OFF] is blink if select to turn on the alarm timer.
SNO O Z E ALARM
When alarm sounds, press SNOOZE to activate the snooze
time 8 minutes.
Ø The AL1 / AL2 indicator keeps blinking.
SET SLE EP TIME R
This clock radio can switch to standby mode automatically
after a preset period.
Press [SLEEP] repeatedly to select the sleep timer period
(in minutes).
Ø When the sleep timer is activated, Sleep indicator is
light on.
To deactivate the sleep timer, press SLEEP repeatedly until
Sleep indicator off.
SET NAP TIMER
1. Press
to clock mode.
2. Press NAP repeatedly to select the nap timer period (in
minutes).
Ø When the nap timer is activated, NAP indicator is light up.
5
environment.
Attention should be drawn to the environmental aspects of
battery disposal.
Electrical products should not be disposal of with household
waste. Please recycle where facilities exist. Check with your
Local Authority of retailer for recycling device. (Batteries pack
or batteries installed) shall not be exposed to excessive heat
such as sunshine, fire or the like.
LO CATI ON OF CO NTRO L
1. STANDBY
4
3
2. MEMORY / TIME SET
5
2
3. TUNING DOWN /
MINUTE
6
1
4. TUNING UP / HOUR
5. VOLUME - / AL2
6. VOLUME + / AL1
7. SNOOZE / DIMMER /
7
SLEEP/NAP
8. SLEEP INDICATOR
9. FM INDICATOR
10
A L1
10. AL1 INDICATOR
A L 2
13
9
FM
11. DIGIT DISPLAY
12
8
12. NAP INDICATOR
SLEEP
NAP
JUMBO DISPLA Y DIGITAL CLOCK RADIO
13. AL2 INDICATOR
11
14. FM ANTENNA WIRE
14
15. DC INPUT
15
16. USB For charging
16
the phone or other
2
To deactivate the nap timer, press NAP repeatedly until NAP
indicator off.
Sleep / Nap Timer period circle as follow :
120 > 90 > 60 > 45 >30 >15 > 05
OFF
ADJ UST VOLU ME
While listening, press + VOLUME – to adjust volume.
ADJ UST DI SPLAY BRI G HTNE SS
Press and hold DIMMER for 2 seconds repeatedly to select high
or low brightness levels.
BATTERY BACK-U P
(For Temporary Time Storage Only)
Install 2 x LR06, AA or EU-3 battery (not included) according
to polarity shown inside the battery compartment. In the
event of a power interruption, your set will not work
normally from the mains supply but there is now the
advantage that your clock will continue to work. The clock
display will not light up, as the clock time will be held in the
memory. This also enables you to move the set from place to
place without re-setting the clock every time. The battery
back-up system is only meant to be used from short
temporary power interruption. For longer durations, the
battery may become exhausted or there may be some
deviation in accuracy. When the battery is exhausted, it
should be removed from the set to prevent leakage. If you
do not wish to take advantage of the battery back-up system,
6
CO NNECT PO WE R
CAUTION
· Risk of product damage! Ensure that the power voltage
corresponds to the voltage printed on the back or
underside of the clock radio.
· Risk of electric shock! When you unplug the AC adaptor,
always pull the plug from the socket. Never pull the cord.
BOTTOM O F SE T
Battery compartment for 1.5 volt (LR6, UM-3, AA) battery
2pcs. (not included) for temporary time storage.
SET TI ME
1. Press and hold TIME SET for two seconds.
Ø[0:00] is blink
2. Press HOUR and MINUTE to set hour and minute
respectively
3. Press TIME SET to confirm
LI STEN TO F M RADI O
For better reception, fully extend and adjust the position of
the FM antenna wire.
1. Press
/ BAND to turn on FM radio.
Ø [FM frequency] is displayed and FM indicator is light up.
2. Press TUNING 〈 〉 for two seconds.
Ø The FM Tuner tunes to a station with strong reception
automatically.
To seach for a radio station manually :
Press TUNING 〉〈 repeatedly to tune to a radio station .
3
your set will work normally without a battery. However, if
disconnected from the mains, the clock figures will flash when
the mains are re-connected and you must re-set the clock as
described in the Electronic Clock Operation paragraph.
Attention should be drawn to the environmental aspects of
battery disposal. Don't throw used batteries in dustbin.
Please contact your retailer in order to protect the
environment.
Attention should be drawn to the environmental aspects of
battery disposal.
Electrical products should not be disposal of with household
waste. Please recycle where facilities exist. Check with your
Local Authority of retailer for recycling device.
(Batteries pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
SP ECI F I CATI O N
Power Source
: 100-240V ~50/60Hz,
Tuner Range
:FM 87.5-108.0MHz
Power Consumption
: 5W
LenoxxElectronics
@LenoxxAustralia
7
Advertisement
