Advertisement
PROPRIETARY RIGHTS NOTICE This document and all information contained within it is the property of Hamilton Beach Brands, Inc. (HBB). It is confidential and proprietary
and has been provided to you for a limited purpose. It must be returned or destroyed upon request. Disclosure, reproduction or use of this document and any information
contained within it, in full or in part, for any purpose is forbidden without the prior written consent of HBB. No photographs may be taken of any article fabricated or assembled
from this document without the prior written consent of HBB.
-
Black cord lead connects to the outside terminal of the circuit breaker switch.
-
Green cord wire connects to the motor ground.
Figure 2. Cord and circuit breaker switch.
PC Board
(see figure 3)
-
The motor field lead closest to the PC board connects to terminal M1. There should be no
current reading.
-
The motor field lead closest to the RFI board connects to terminal M2. There should be line
current when cycle start is activated.
-
One white lead from the cord connects to terminal N. There should be no current reading.
-
The black lead from the center terminal of the circuit breaker switch connects to terminal L.
There should be line current present.
-
The 4-conductor cable from the LED cycle counter connects to terminal J7.
-
The 3-conductor cable from the speed control connects to terminal J8.
-
The 2 – 3-conductor cables from the jar sensors connect to terminals IC3 and IC4
-
The lead from terminal P1 on the RFI board connects to the P1 terminal on the PC board.
-
The lead from terminal P2 on the RFI board connects to the P2 terminal on the PC board.
Note: When making the following connections "top" and "bottom" are relative to the machine assembled
and sitting upright.
-
"Off " terminal lead connects to the top terminal of the on/off switch.
-5 VDC reading with switch in off position.
-
"On" terminal lead connects to the center terminal of the on/off switch.
-5 VDC reading while the machine is running.
-
"Start" terminal lead connects to bottom terminal of the on/off switch.
Momentary -5 VDC when start switch is activated.
-
"Pulse" terminal lead connects to the top terminal of the hi/low/pulse switch.
Revision Description:
Request Number:
4421 Waterfront Drive
Glen Allen, VA 23060
Issue Code(s):
ENG-FRM-RIC-4.32, Rev. E
Technical Data Sheet
Production Release
DOC2649
Revision Date:
2
CS, SP
Page:
4/17/12
4
Document #:
of
Approved by:
DOC2649
520006200
Rev:
A
Advertisement
