Vanguard EN-5T Owner's Manual

SPECIFICATIONS

FREQUENCY RANGE
HIGH FREQUENCY DRIVER
LOW FREQUENCY DRIVER
SENSITIVITY
POWER HANDLING
70V TAP SETTINGS
IMPEDANCE
ENCLOSURE MATERIAL
ENCLOSURE TYPE
FINISH
PRODUCT DIMENSIONS
PRODUCT WEIGHT

INTRODUCTION

The Vanguard Dynamics EN-5T is an indoor/outdoor speaker capable of 8 ohm or 70V loads designed to provide flexiblity in different install
environments. The durable all weather enclosure is matched with a acous�cally tuned 5" woofer and 1" tweeter filling any indoor or outdoor
zone with full and rich sound. Hang them from the ceiling as pendant speakers, mount them on any surface or tree, or simply stake them in
your garden crea�ng your personal concert hall. Adding 70v se�ngs allows for ul�mate flexibility in commercial applica�ons, with an input
and output loop directly on the speaker, daisy chaining never got easier.

SPEAKER PLACEMENT

• If you desire music over a wide area, it is best to have a larger number of speakers playing at low volume, rather than a few speakers playing
at high volume. Keep this in mind when designing your outdoor system.
• Ideally, you should place the speakers as close to the primary listening area as possible. The perceived volume of the speaker decreases
rapidly as it is moved further from the listener.
• Direct burial wire or conduit for new yard construc�on must be run to the loca�on of the speakers. Keep in mind that pa�os, walls and other
features in your yard may be di cult to get around when wiring.

CONNECTING THE SPEAKERS

1. The 4-pin Euroblock plug allows for speaker wire input as well as speaker wire output to easily daisy chain speakers in 70v applica�ons.
2. Determine the loca�ons for the speakers and es�mate the length of addi�onal wire you will need for each speaker.
NOTE: WHEN PURCHASING ADDITIONAL WIRE, VANGUARD DYNAMICS STRONGLY RECOMMENDS USING DIRECT BURIAL GRADE WIRE.
3. Dig a 4" – 5" deep trench to run the speaker wires in.
4. Run the wire through the trench from your amplifier to the speaker loca�ons. Do not connect the wires to the amplifier at this �me.
5. Connect the speaker wires you ran from your amplifier to the wires that came a�ached to the speakers. Vanguard Dynamics recommends
using waterproof wire nuts (not included) to secure the wires.
IMPORTANT: BE SURE NOT TO LET ANY STRAY '+' AND '–' STRANDS TOUCH EACH OTHER. TOUCHING STRANDS CAN CAUSE A SHORT- CIRCUIT
THAT COULD DAMAGE YOUR AMPLIFIER
6. A�er you have made the above connec�ons, connect the wires to your amplifier.
NOTE: CONFIRM THAT YOU HAVE CONNECTED SPEAKER "+" TO AMPLIFIER "+" AND SPEAKER "–" TO AMPLIFIER "–"
7. Turn your amplifier on and test the system with your favorite music. If the speakers are opera�ng properly, refill the wire trench and enjoy
your new speakers.
EN-5T
130Hz - 20kHz +/- 3dB
1" (2.54cm) PEI Dome Tweeter
5" (12.7cm) All-Weather PP Woofer
87 dB
40W RMS
70V: 1.25W, 2.5W, 5W, 10W
8 Ohm
UV Treated, Glass-Filled ABS Cabinet
Sealed
Brown Ma�e, Paintable
6.7" x 9.5" x 9.6" (169mm x 240mm x 244mm)
w/ Surface Mount
4.4 lbs (2 kg)
EN-5T
Owner's Manual
8 OHM/70V INDOOR/OUTDOOR
COMMERCIAL SPEAKER