Liberty Grandview Skyshow D Series User Manual

Use a small pin fit to size to insert into positioning setting
keyhole at rear side of remote and press it to make the light on.
Then press "down" key on remote to operate screen to go
down. When screen moves to the required position, then press
"stop" button. And please press positioning setting keyhole
with pin again. This is the down positioning set as required.
Please follow the same to set up limit, Please check below:
Note: Maximum travel distance of steel wire is 5meters.
C. LVC:
EXTERNAL
Simply contact
CTRL
RJ12 6P6C connector.
UP UP
From left to right, 3-6
DOWN
DOWN
123456
is control signal cable,
RJ12
RJ12 STOP
STOP
6
6
5
3 is common cable, 5
4 COM
COM
4
3
3
2 2
4 is stop, 5 is lower, 1
1
6P6C
6P6C
6 is lift.
D. RS485 or RS232 :
From left to right, 1 & 2 cable for control.
For RS485, cable 1 is D-, cable 2 is D+. The
connecting of RS232 as figure shows.
RS485/RS232 control protocal:
Baud Rate: 2400
Data Bits: 8
General Port
Stop Bits: 1
Parity: None
Hex command:
Screen UP: ff ee ee ee dd
Stop: ff ee ee ee cc
Down: ff ee ee ee ee
In some cases you may need to
enable the RS-232 control by
sending hex command:
ff ee ee ee aa
Note:
When setting RS232 or RS485, if the screen is not able to
operate as it is, please switch position of No. 1 and No. 2.
The electric resistance of return circuit is less than 20Ω.
Do not do wiring nearby interference sources.
Setting for Up and Down Limited Positioning for Motor:
The limited positioning of motor has been defaulted when
EX-factory, it is not allowed to reset.
Screen: Voltage AC220-230V/50-60HZ, 0.8Amp, power 190watts.
RF remote(F): Voltage 3V, use CR2450*1 battery.
Radio Frequency: 433Hz. maximum control distance 15m.
Protecting your Screen:
To ensure long lasting viewing enjoyment keep
the screen rolled up when not in use. Check both
the front and back surfaces before retracting into
the case to make sure it is free of dust, dirt, insects
or other foreign matter. Use a soft brush or cloth to
S1
S1
lightly remove any foreign particles.
S2 S2
S3
S3
Trigger control
Cleaning your Screen:
Use warm water with a mild detergent to remove
P1
6
5 1
4 6
any marks on the surface or screen casing (only
2
3
7
2
TXD
3
dab, do not rub). Immediately dry the screen with
1
8
6P6C 4
9
a soft cloth or towel. Do not leave it to air dry.
GND
5
DB9
USB Serial Port (COM3) Property
Drive Program
Detail Event
Never use any solvents, chemicals or abrasive
cleaners on the screen surface as they can
Baud Rate: 2400
permanently damage the screen surface.
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
Advanced Restore
Confirm Cancel
User Manual for SkyShow
Series Model D
Integrated Motorized Screen
Suitable for Model Named SK-MI(F)