Connections And Buttons; Installation - MPI Technologies EasyCom 5 Quick Manual

ENGLISH
The EasyCom 5 PrintServer services a single matrix printer. The
EasyCom 5 connects to the printer via a) USB to USB, b)
Centronics via an adapter cable, or c) via the printer networked
port.
This Quick Guide explains how to install your PrintServer. Please
consult the EasyCom 5 User Guide for more information.

Connections and buttons

 The PWR plug is for the 5V 1A power supply.
 The OTG plug is for configuration via ethernet over USB.
 The USB plug connects a printer via USB cable.
 The LAN port connects the EasyCom 5 to the network.
 The PRT port connects a printer via network cable.
 The TEST button is for printing a test and configuration page
of the PrintServer. Press the TEST button between 8 and 60
seconds to reset settings to factory defaults. The box will
reset upon releasing the TEST button.

Installation

1. Make sure no power cord is connected to the PrintServer
2. Connect the PrintServer's "LAN" port to the network.
Connect the printer to the "USB" port. Use standard USB
printer cable or USB Centronics adapter cable.
Please consult the EasyCom 5 User Guide if you wish to
connect the printer via network connection.
3. Power on the printer.
4. Locate the USB cable with micro USB/USB A. Attach the
USB A plug into the supplied power adapter. Carefully
slide in the Power PIN micro USB plug into the "PWR"
socket on the PrintServer. Please observe correct
orientation.
5. Insert the power adapter to the power outlet and power
up the PrintServer.
6. The green LED's on the PrintServer front will blink during
the power on and self-test cycle. Only use the power
supply provided with the product. The output is rated
5vDC, 1A.