Page 2
LABOR, FROM DATE OF SHIPMENT. END-USER OR RESPONSIBLE PARTY MUST NOTIFY ROYALTON FOOD SERVICE EQUIPMENT CO. FIRST WITH A MODEL AND SERIAL NUMBER AND WHAT TYPE OF PROBLEM IS OCCURRING. AT THAT TIME AUTHORIZATION WILL BE GIVEN AND PARTS WILL BE SENT TO THE END-USER OR SERVICE AGENCY.
Avoid getting water inside the control module, because it ruins the electrical components and VOIDS THE WARRANTY. ο NEVER locate your Royalton unit next to grease emitting equipment such as deep fryers or griddles. ο DO NOT block louvers or cooling fans in the control module.
Page 4
9981 York-Theta Drive, North Royalton, Ohio 44133 440-237-0806 FAX: 440-237-1694 1-800-662-8765 VENTING IN GENERAL, THIS APPLIANCE DOES NOT NEED TO BE PLACED UNDER A HOOD. CONSULT YOUR LOCAL HEALTH AND FIRE CODES FOR REQUIREMENTS IN YOUR AREA DO NOT LOCATE APPLIANCE UNDER AN OVERHEAD VENT HOOD CLOSE TO OTHER COOKING EQUIPMENT BECAUSE: 1.
9981 York-Theta Drive, North Royalton, Ohio 44133 440-237-0806 FAX: 440-237-1694 1-800-662-8765 STACKING KITS PLACE TOP CABINET, WITH NO BASE AND NO CASTERS, ON TOP OF BOTTOM CABINET WITH BASE AND CASTERS. LINE UP THE TOP CABINET'S BACK END W ITH THE BACK END OF THE BOTTOM CABINET.
9981 York-Theta Drive, North Royalton, Ohio 44133 440-237-0806 FAX: 440-237-1694 1-800-662-8765 OPERATING INSTRUCTIONS FOR SS2-KNOB CONTROLLER TO COOK USING TIMER: 1,) POWER SWITCH ON. 2.) SET COOK TEMP. (KNOB) 3.) SET HOLD TIME. (KNOB) 4.) ALARM SOUNDS WHEN PRE-HEATED (PRESS CLEAR ALARM).
OVEN OPERATION To Set Clock Note: Clock Must Be Set to Operate Oven I. Press Or/Off to Off (No Light) 2. Press Enter in Time Area for 3 Seconds 3. Press Arrow Keys for Correct Day 4. Press Enter 5. Press Arrow Keys for 12or 24Hr.
Page 8
To Pre-Heat Cook & Hold Solid-State Digital Control Note: Clock Must be Set to Operate Oven See: To Set Clock 1. Press Power On 2. Press Pre-Heat 3. Press Arrow in Temp Area to Desired Temperature and Press Enter. Note: If Enter is not Pressed Within 5 Seconds Temperatures and Times will Revert to Previous Settings 4.
Page 9
SETTING PROGRAM SELECT 1. Press Power On 2. Press Select to Light First Label Area 3. Press Pre-Heat 4. Press Arrow Temp Area to Desired Temperature and Press Enter 5. Press Roast 6. Press Arrow in Temp Area to Desired temperature and Press Enter 7.
Page 10
To Pre-Heat Cook & Hold Using Program Select 1. Press On 2. Press Select to Light Desired Program 3. Press Pre-Heat and Press Start Note: Oven Beeps When Pre-Heated Press Clear to Stop Beeps 4. Load Product Into Oven 5. Press Start/Stop to Stop Pre-Heat 6.
Need help?
Do you have a question about the SS1 and is the answer not in the manual?
Questions and answers