Kimberley KSV200 Installation Instructions

Before you begin

Before beginning the installation of your new solar powered roof ventilator, please read the instructions carefully and contact us if you
have any questions. kimprod@kimprod.com.au or Ph: (03) 9768 5777
For optimum performance, position the solar ventilator in a north facing position on an area of the roof where it is not shaded or blocked.
This will ensure the solar device can capture all available sunlight throughout the day.
For your safety we recommend that you always use appropriate safety equipment when working on your roof. Ask for assistance when-
ever attempting any heavy lifting.

INSTALLATION TO A TILED ROOF

Top
Bottom
(Turn-up lip)
SOLAR ROOF VENTILATOR
INSTALLATION INSTRUCTIONS - TILED ROOF
MODEL KSV200
kimprod.com.au
Remove 3-4 Tiles at the desired location.
Position your Solar Roof Ventilator on to the roof battens. Mark
where screws are to go into battens.
Drill a 6mm hole as per diagram. Two holes may be suitable for
cyclonic or high-wind areas. You may need to check your local
regulations.
Using 50mm Type 17 wood screws, secure roof vent into battens.
Replace your tiles back into position, top and sides
Depending on size of tiles, they may need to be cut to size to fit.
Place a bead of silicon on the edges of the two side tiles and outer
edges of base of unit. See diagram (Squares indicate silicone loca-
tions).
Depending on the distance between your battens, a secondary
batten may need to be introduced to offer additional support for the
ventilator unit.

Tools Required:

Drill
6mm drill bit
Grinder with diamond wheel
Silicone gun
4x 50mm screws
SEE OVER FOR METAL DECK ROOF INSTALLATION
1
2
3