- This gate closer is mounted on the swing/open side of the gate and pushes the gate closed.
- A Gate Stop must be installed to keep gate from opening beyond 90 degrees.
- If using tension/spring hinges, release all tension and remove spring closers.
- Do NOT use with bulldog/strap style hinges. For best results, use male/female style hinges.
No.
Part Name
1
Hydraulic Cylinder
2
Post Bracket (Triangular)
3
Gate Bracket
4
Fitting Bar
5
Securing Pins (Hexagon Head)
6
Spacers
7
Cap Screws
8
Washers
9
Retaining Bar
KEY:
= Hinge Pin
= MUST measure 2-4"
Step 1: Secure Post Bracket (#2) to Gate Post *This step is the MOST important. The Post Bracket (#2) MUST be mounted first.*
Hold Post Bracket (#2) to the face of the gate post.
Measure from the center of the first hole on Post Bracket (#2A) to the center of the Hinge Pin .
This measurement MUST be between 2" and 4".
Clamp bracket into place.
Note: Regardless of hinge arrangement, the measurement from the center of the Hinge Pin to the center of hole 2A on Post Bracket (#2)
must not exceed 4" or damage to the gate closer may occur.
= MUST measure 2-4"
Gate
Gate
Post
Post
Step 2: Measure/Secure Gate Bracket (#3)
With gate in closed position, attach Fitting Bar (#4) to Post Bracket (#2) using a Securing Pin (#5) in hole 2-D (shown below (left)).
Next, place a Securing Pin (#5) in the opposite end of the Fitting Bar (#4) and secure to the Gate Bracket (#3).
Hold Gate Bracket (#3) to the gate and clamp into place.
The distance from the center of hole 2-D and the center of the Gate Bracket must measure 29 3/8".
Clamp/secure brackets then remove Fitting Bar (#4).
Note: If wall mounting, use Gate Bracket (#3) on the wall and the Post Bracket (#2) on the gate (shown below (right)).
Gate in CLOSED position
Gate
Post
2A
2B
2C
2D
Qty.
1
<--- Gate End
1
1
1
2
4
2
2
1
INSTALLATION INSTRUCTIONS:
Gate
Post
Gate
= 29 3/8"
Hydraulic Gate Closer
TB200, TB400, TB600
Installation Instructions
Important:
Post End --->
Gate
Post
Gate in CLOSED position
Gate Closer
36" Gate
Added Opening Force
No Closer
3/4 lb.
TB200
6 lbs.
TB400
10 lbs.
TB600
13 lbs.
Added Force at 45 degrees Open
TB200
7 lbs.
TB400
13 lbs.
TB600
18.5 lbs.
Constant
Closing
Approximate
Pressure
Width
0 lbs.
45 lbs.
36-52 Inches
90 lbs.
40-64 Inches
135 lbs.
44-72 Inches
Chainlink
Post
Gate
= 29 3/8"
Wall Mounting a TB Gate Closer
(may restrict 90 degree opening)
48" Gate 60" Gate
1/2 lb.
1/4 lb.
4 lbs.
3 lbs.
8 lbs.
6 lbs.
10 lbs.
8 lbs.
5 lbs.
4.5 lbs.
9.5 lbs.
8 lbs.
13.5 lbs.
12 lbs.
Approximate
Weight
50-125 lbs.
75-175 lbs.
150-250 lbs.
Chainlink
Post
2A
2B
2C
2D