CCTVCO MAX-IP280 Quick Manual

MAX-IP280
Quick Guide
1.0 Installation
Begin by applying a 12v power supply to the
camera and connecting your Max-IP280 to your
network once you have mounted your camera.
2.0 Install both the IPCamera Search and
SuperIP Cam applications on your PC.
Note * Your Max-IP280 must be on the same
network as the PC running the IP Camera Search.
You may also use a crossover cable direct from the
camera to your PC.
3.0 Now run the IPCamera Search
Application
The following window will open.
Click the search button. If your connection is
properly done and your Max IP280 is on the same
network as your PC you will see the MAC address
of your MAX-IP280 appear. This indicates that the
software has found your camera and is ready to be
configured.
In the LAN section you will notice the IP
configuration of your PC and the WAN IP of your
current network. The WAN IP is the IP you will
use to to connect to your IP camera when outside
your network.
4.0 Configure IP Camera
The next step is to click and highlight the MAC
address for the IP camera. This will display the
IP information in your MAX-IP280. You may
manually change the IP address in the IP camera
if you would like or click the AutoSetup button
to have the Software do this for you.
Note* Ensure that the DNS IP on your IP
camera is the same as your LAN DNS. If this is
incorrect you will not be able to view your
camera remotely.
Next select the HTTP port you would like
to use to view your camera remotely. The
default port is 80. You will now need to open
this port within your router to view the
camera remotely. If you will only be using
this camera on your local network you do
not have to open this port on your router.