Beat-Sonic MVA-23WD1 User Manual

23/23WD
MVA-
Thank you for your purchase of MVA-23. The following document is written to describe the
installation rocess of this roduct.

Features:

1.Can remove the OEM head unit and attach 201N size aftermarket unit/navigation with the amplifier.
2.Can use OEM navigationfTVas it is.
Can display the image on the factory screen(items needed are not included).
3.
Cautions
I. Compatible with cars with Super Live Sound System(7&9speakers) Multi-Vision{EMV) .
2.Cannot use rear controller.
3 .Cannot use CO changer and optional OVO changer.
p fi
,
4 .Because of the 2ch OEM am li er the effect from the additional unit such as fader/DSP cannot work
properly.Only when used by Multi-Vision, fader work with the additional unit.
5
.Adjust the volume using both the factory unit and the new(aftermarket) unit.
6. Cannot use the OEM FM/ AM radio. Need to attach the supplied antenna cable from the trunk to
the back of the unit when listening to FM/AM radio using the new head unit.
7. Need the TV controller (not included) to see the TV or display the image from the new head unit
on the screen of the OEM unit while driving.
Attached panel color
·MVA-23 OEM Color •MVA-23WD1 Light Brown Color

Specification

2 40mm 26.Smm
Installation DIN- Width x Height

Included in this kit

Audio electronic adaptor, Face plate , Brackets(UR), Antenna cable
Mount all components in locations that will not inhibit safe driving or obstruct the motions of the various
h
e vehilce function. Be cautious so as not to damage wires, piping,tanks and other areas as
components o f t
oo not installed in the vehicle. Avoid wet, dus
Any damages resultmg to the automobile of aftermarket aud1o systems as result of mproper 1nstallat1ons or careless
mstallat1on prodecures are not covered by any warranty nor are
from the Installation process Please observe caut1on when perform1ng 1nstallat1on
cautoo n
MVA-23

Antenna cable connections

Connent an antenna
r
cable to (A the ight
bottom of the trunk).
Remove the wirin Sl
harness attached to
(A radio tuner), then
attach to the extension
cable. Extend the antenna
plug to (C the back of
the unit) through the
r
wi ing hole located in
B(the back of the backseat.)
/23WD2
1
User's Manual
Model
Year
ation 2001-2003
p
x 82mm 1
De th Weight: SOg(only adaptor)
,
ty i
or areas of extreme temperatures for nstallation
respons1ble for any In Junes or damages resulting
we
o
o
Black/Ground
Red/Ignition Power ACC
Yellow/Battery Constant
20Pin Lexus Head Unit
�
Harness pier
Lexus Head Uni
12Pin
Harness Coupler
..
-Always disconnect the negative(-) terminal of the vehicle battery and drain all capacitors
N0:000001
before installation.
-Use the masking tape to label the wires passing near the metal part of the car
-After the installation, make sure the brake lamps, headlights, turn signals and
wipers work properly.
Before startmg mstallat1on. venfy that the ongmal aud1o system 1n the veh1cle 1s fully funct1onal. Th1s k1t will
remedy any 1ssues that ex1sted before the mstallat1on or faults 1n t h e on
Model Chassis Code
{D
UCF30, UCF31 Removal of the Factory
Remove the switch panel below the
1.
Remove the center compartment(3 screws,
2.
Remove the switches from the center compartment.
Remove the
3.
Remove the hazard switch from the OEM
unit(2 screws)
.
c£})
Installation of Aftermarket Audio/NAY Head Unit
1. Secure the brackets (UR) to the aftermarket unit using the screws(the holders and screws
New
o are supplied).
Head Unit
o
2.
Cl ip the hazard switch (from the factory unit) and the switches (from the
center compartment) into the supplied trim paneL
*Take off the lid for the hole on the
trim panel when you have more
than 2 switches.
3.
Slide the aftermartket unit into the cage and secure
using the factory bolts (2 bolts).
Attache the trim
4.
Attach the OEM
c@
When completing the setup, make sure the audio system works properly.
Audio Head Unit
OEM
OEM unit(2 hooks)
hooks).
6
OEM
unit(2 bolts, 2 hooks).
**Put back the switch panel after the supplied panel.
... - · · · · · · ·. : \
OEM bolts
switch panel to the dashboard.
8 ffi
gm
al systems 1n the veh1cle