Projection Pro Billiards Quick Start Manual

projection pro billiards quick start guide
What's included:
1. Microcomputer
2. Micro SD card
3. Power cord
4. Flash Drive
5. Downloadable Drill Calibrating Tool
Not included:
1. Projector-minimum of 3300 lumens in required. Viewsonic PJD 5155 or 5255
highly recommended
2. HDMI cord
3. Wireless mouse
Step 1: Set up your projector according to manufacturers instructions. The projected
light must go from the edge of the bottom rail to past the top rail. Your projector should
be approximately 6 feet away from the edge of the table and 7 feet high. All set-ups
are different, you may have to adjust according to the dimensions of your room.
Step 2: Set up the microcomputer. Plug one end of the HDMI into the projector and
the other end into the microcomputer. Plug in microcomputer's power cord. Insert
USB dongle for wireless mouse into one of the USB ports on the microcomputer.
Step 3: Calibrate your table. On first start-up, calibrating your table is mandatory.
Turn on projector. If "Category Selection" screen appears, click on the X to close
window. Right click anywhere on your pool table, scroll down to APP and then click
Calibration. A pop-up window will appear "would you like to start calibration"? Click
YES. You will now see 4 small boxes projected on your table. You need to position
each box to the center of the long and short rail outermost diamond points as seen
below.