Arne
Column mount LED Light
Installation Guide
Included components
1/4‐20 x 5/8" button
4.5m
6m
8m
10m
Pole with base plate
Tools Required
• Safety glasses
• Wrenches: 1‐1/4" for 4.5m and 6m poles or 1‐5/8" for 8m (5in/7in) and 10m (5in/8in) pole
• Wiring tools and connectors
• Proper personnel, crane or lift for hoisting unit onto anchors
• Level
• Dimming control, if required
• Hex key 5/32" for nut covers
• Twist lock photo eye, if required
• 4mm and 6mm hex keys
• 13mm wrenches
• 17mm socket wrench
Landscape Forms is not responsible for site preparation and footings. Refer to the
installation guide for the Arne light anchor kit for installing the anchor bolts.
CAUTION! This unit is heavy. To avoid injury or damage to the finish, we recommend using
a crane or lift for hoisting the unit onto the anchors.
WARNING! Pole mounted luminaires must be attached either before or immediately after
pole installation. Failure to do so may cause vibration damage to the pole and will void the
pole warranty.
ASSEMBLE WITH CARE! To protect this finish during assembly, place unwrapped powdercoated parts on
packaging foam or other non‐marring surface. Do not place or slide powdercoated parts on concrete or
other hard or textured surface – this will damage the finish causing rust to occur. Use touch‐up paint on
any gouges in the finish caused by assembly tools.
Twist lock receptacle,
Column mount
luminaire
bracket
Shorting cap for
Twist lock, optional
4X ‐ Nut cover with
head cap screw
Standard
Pole cap
INSTALLATION PROCEDURE FOR LIGHT POLE:
1.
Lift the light pole into position over the installed anchors (refer to Arne anchor kit
installation guide) as shown in Fig. 1. Ensure that the base plate is resting on all four
washers.
2.
Install washer and hex nut as shown in Fig. 2.
optional
3.
Plumb and level the pole and tighten all anchors.
4.
Install luminaire. Refer to page 2 for mounting luminaire to pole.
5.
Make electrical connections. Refer to wiring diagram.
6.
Install the top cap on the pole (shipped with the pole). If the unit has a twist lock
receptacle, assemble the receptacle and the top cap as shown in Fig. 3 and connect
wiring before installing the top cap.
7.
Install the nut covers as shown in Fig. 4.
For twist lock
SIDEWALK
Fig. 1 – Pole orientation
Fig. 3 – Install twist lock
receptacle to top cap
www.landscapeforms.com
HAND HOLE
ORIENTED ON
SIDE OPPOSITE
OF LUMINAIRE
SETBACK
Fig. 2 – Install pole
Fig. 4 – Install nut covers
Date: November 6, 2017
Ph: 800.521.2546
Page 1 of 4