Advertisement
power loss.
5: Two 4-pin 5v inputs ports. The 4-pin ports will allow you to sync one of our breakout board adapters to another of our
breakout board using our 4-pin cable. DO NOT CONNECT ANY OTHER CABLE TO THIS PORT AS IT WILL
DAMAGE THE BREAKOUT BOARD.
6: LED voltage display. This will provide you with the current voltage output of the power supply.
Interconnect Sync Instructions
Every order containing 2 or more breakout boards will include a free interconnect sync cable to chain each breakout board together.
The cable is approximately 19 inches long.
These breakout boards have two 4-pin input ports; you can sync any amount of power supplies together by connecting the 4-pin port
to the next breakout board's 4-pin port and so on. We have tested up to 20 linked PSUs.
By syncing the power supplies, you will be able to power on/off all power supplies in the chain by pressing the power button on any
one of the breakout boards in the chain. In the event that one power supply gives out and is no longer working, the sync will not be
interrupted; all working power supplies will still power on/off together.
Dual Fault Protection Instructions
Dual fault protection is the ability to link two power supplies together in
such a way that if one power supply fails, then the second will
automatically shut off. This mode renders the on/off power button
inoperative; turn the PSUs on and off by inserting or removing the power
cord. The dual fault protection cables cannot be used together with the
interconnect sync cable.
Connect the molex of one cable to the first PSU, then connect the 4pin end
of the same cable to the second PSU, connect the molex of the second
cable to the second PSU, and then connect the 4pin to the first PSU.
Watch all features in action here:
https://www.youtube.com/embed/KYPKXVuHFWc
Parallel Miner's X6B to X12 Breakout Board Manual |Revised May 2018
2
Advertisement
