WILDWOOD OVENS &BBQ’S GAS BARBECUE MACHINE Instruction Manual

Advertisement

Quick Links

INSTRUCTION MANUAL
FOR GAS BARBECUE MACHINE
Wildwood Ovens and BBQs
5020 Eagle Rock Blvd Los Angeles, CA
90041
www.wildwoodovens.com
323.255.6578
800.579.2797
1

Advertisement

Table of Contents
loading

Summary of Contents for WILDWOOD OVENS &BBQ’S GAS BARBECUE MACHINE

  • Page 1 INSTRUCTION MANUAL FOR GAS BARBECUE MACHINE Wildwood Ovens and BBQs 5020 Eagle Rock Blvd Los Angeles, CA 90041 www.wildwoodovens.com 323.255.6578 800.579.2797...
  • Page 2: Table Of Contents

    CONGRATULATIONS! You have just purchased a product with the latest technology, performance and design. Now, it will be much easier and faster for you to prepare your meats. To ensure optimum performance of your machine, read and follow the instructions carefully. Should you have any doubts and/or questions feel free to give us a call.
  • Page 3: Warnings

    WARNINGS WARNING: Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment WARNING ELETRICAL GROUNDING INSTRUCTIONS: This appliance is equipped with three-prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle.
  • Page 4: Introduction To Operator And Maintance Manual

    INTRODUCTION TO OPERATOR AND MAINTANCE MANUAL This manual provides technical information for the correct installation and operation of the equipment. The operator has the duty and responsibility to be knowledgeable of and familiar with the contents. Contents include a description of the characteristics, operation, installation and maintenance, as well as operator safety.
  • Page 5: Measurements For Hydraulic Parts

    WATER TANK The gas barbecue machine has a stainless steel water tank located inside of the machine. All gas models do not produce any smoke formation due to this water tank. Prior to turning on the burners and rotisserie system, the water thank must be filled with water.
  • Page 6: Gas Connection

    GAS CONNECTION An adequate gas supply is imperative. Minimum gas supply pressure 7° W.C. for Natural Gas and 11° W.C. for Propane. The gas entrance pipe has 1” diameter. All sectional units require a regulated gas supply. If using a flexible-hose gas connection the inside diameter of the hose must not be smaller than the connector on the unit providing an adequate means of restraint to prevent undue strain on the gas connection.
  • Page 7 TABLE SIZES AND DETAILS Galleries Skewers Burner Motor Consumption BTUS Width Depth Height (Kgrams/h) ¼ HP 0.76 35712 31 ½” 27 ½” 67” ¼ HP 0.95 35712 35 ½” 27 ½” 67” ¼ HP 1.14 53568 39 3/8” 27 ½” 67”...
  • Page 8 TABLE SIZES AND DETAILS Galleries Skewers Burner Motor Consumption BTUS Width Depth Height (Kgrams/h) ¼ HP 0.76 35712 31 ½” 27 ½” 63” ¼ HP 0.95 35712 35 ½” 27 ½” 63” ¼ HP 1.14 53568 39 3/8” 27 ½” 63”...
  • Page 9: Gear Lubrication Care

    GEAR LUBRICATION CARE To keep the rotisserie system in good condition and to ensure a long product life it is essential to lubricate the back gears with oil only. We recommend 30-40 weight motor oil for this maintenance. Please follow the instructions and picture below: Disconnect the machine from the power source and allow the machine to cool if it has been recently used.
  • Page 10: Infrared Burner

    COOKING PROCEDURE Cut your meat according to the style and recipe you are using. For Brazilian churrasco we recommend use only high quality coarse sea salt to prepare the authentic Brazilian churrasco but you can also marinate them with your favorite seasoning.
  • Page 11: Cleaning

    CLEANING Before cleaning the equipment, make sure it has been unplugged from the power supply. 4.2 Always clean equipment after each use. 4.3 Do not use any Sharp objects such as knives, metal spatulas, ice pickss, etc. to clean the equipment. 4.4 Use soap and water and a cloth to clean the machine 4.5 Make sure all water is removed and the tank is dried.
  • Page 12  Electricity plug furnished with 6’ cord with self grounding plug; Hydraulics: Fill and flush out the tank as necessary, to facilitate the cleaning of the tank.   In let water pipe ¾ - Face the machine in the back left side; ...

Table of Contents